Fusion FP-188 and FPH-188 - Vinten Radamec
Fusion FP-188 and FPH-188 - Vinten Radamec
Fusion FP-188 and FPH-188 - Vinten Radamec
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Fusion</strong> <strong>FP</strong>-<strong>188</strong> pedestals <strong>and</strong> <strong>FP</strong>H-<strong>188</strong> height drives<br />
22<br />
2. Depress <strong>and</strong> rotate the automatic/manual height mode knob [20] anti-clockwise to<br />
select manual operation. Depress <strong>and</strong> rotate the cable release button [37] clockwise<br />
to disengage the robotic height drive.<br />
NOTE: It is only possible to depress <strong>and</strong> rotate the cable release button when the column<br />
is fully depressed.<br />
3. Push down on the steering ring [19] against residual pressure <strong>and</strong> release the<br />
column lock [6]. Allow the column to extend under h<strong>and</strong> restraint.<br />
4. Fit the pan <strong>and</strong> tilt head to the four-hole mounting plate [2] <strong>and</strong> tighten the bolts<br />
supplied with the head securely using a flat-bladed screwdriver or a spanner of the<br />
correct size. A <strong>Vinten</strong> spanner (part no. J551-001) is available for this purpose.<br />
5. Set the column lock [6] to the ON position (see Using the column lock on page 26)<br />
<strong>and</strong> lower the moving column under h<strong>and</strong> restraint until the column lock engages.<br />
6. Fit the camera <strong>and</strong> accessories. Ensure that all equipment (incl. pan bars,<br />
prompters, lenses, etc.) has been securely fitted. Attaching equipment at a later<br />
stage can upset the pedestal balance.<br />
7. If the pedestal or height drive is being used manually, install three trim weights in<br />
the weight tray [5].<br />
Mounting a Quickfix ® adaptor<br />
In situations where heads are often interchanged on pedestals <strong>and</strong> tripods, it is recommended<br />
that a <strong>Vinten</strong> heavy-duty Quickfix adaptor (part no. 3490-3) is used. The adaptor provides an<br />
easier <strong>and</strong> quicker method of mounting <strong>and</strong> removing heads from a pedestal or tripod. Mount<br />
the adaptor onto the pedestal or tripod mounting plate <strong>and</strong> secure into position following the<br />
installation instructions in the Operators Guide supplied with the adaptor (part no. 3490-8).<br />
Fig. 6 Mounting a <strong>Vinten</strong> heavy-duty Quickfix adaptor on an <strong>FP</strong>-<strong>188</strong> pedestal