Fusion FP-188 and FPH-188 - Vinten Radamec

More documents

Recommendations

Info

Fusion FP-188 pedestals and FPH-188 height drives Maintenance General This pedestal is robustly made to high engineering standards and little attention is required to maintain serviceability. Attention to the following points will ensure a long and useful service life with minimum need for repair. Cleaning During normal studio use, the only cleaning required should be a regular wipe over with a lint-free cloth. Dirt accumulated during storage or periods of disuse may be removed with a vacuum cleaner. Particular attention should be paid to the bearing strips [38] on each stage of the column, the wheels [33] and datum reference sensors [8.2] (see Fig. 10). CAUTION! 1. Do NOT use oil or grease on any exposed part of the column. This is unnecessary and traps dirt which acts as an abrasive. 2. Do NOT use solvent- or oil-based cleaners, abrasives or wire brushes to remove accumulations of dirt as these damage the protective surfaces. To clean mechanical surfaces, use only detergent-based cleaners. Accessing the wheels and datum reference sensors To gain access to the wheels [33] and the pedestal datum reference sensors [8.2], it is necessary to remove the two access panels [8] on opposite sides of the pedestal base, below the lifting handles [7] (see Fig. 10 below). To remove these panels, proceed as follows: 32 1. Switch OFF power to the pedestal [22] and disconnect the power lead [31] (see Fig. 2 on page 14). 2. Unscrew the four fixing screws [8.1] and lift off the panel [8] to expose the internal mechanisms. Routine checks During use, check the following: 1. Check the balance of the pedestal. Rebalance as necessary. 2. Check the data communication with the control panel. Refit cables, if necessary. 3. Check for radial or side play in the moving column.
[8.2] Adjustments Fig. 10 Accessing wheel and datum referencing sensors Operators guide If excessive radial or side play is apparent in the moving column, wheel alignment is poor or any other defect is apparent, contact Vinten Radamec or your Vinten Radamec local distributor. Adjustments and repairs should only be carried out by a trained and competent service engineer. [8.1] [8] 33
Page 1: FP-188/FPH-188 Pedestals and Height
Page 4 and 5: Publication Part No. V3952-4985 Iss
Page 6 and 7: Fusion FP-188 pedestals and FPH-188
Page 36: Fusion FP-188 pedestals and FPH-188

Fusion FP-188 and FPH-188 - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?