Owner's Manual - At Andiron Fireplace Shop

I. Chimney Termination Requirements• Install a cap approved and listed for this fi replace system.• Locate cap where it will not become plugged by snow or other materials.• Locate cap away from trees or other structures.• The bottom of the termination cap must be at least 3 ft (.91 m) above the roof AND at least 2 ft (.61 m) above any portionof roof within 10 ft (3.05 m) as shown in Figure 8.10.• See below for distance required between caps.Slanted RoofsChimney mustextend 3 ft (.9 m)above the roofChimney must extend 2 ft (.6 m)above any portion of the roof oradjacent structures within10 ft (3 m) of the chimneyFlat RoofsChimney must extend 2 ft (.6 m)above any portion of the roof oradjacent structures within10 ft (3 m) of the chimneyChimney mustextend 3 ft (.9 m)above the roofTermination RequirementsGasTermination18 in.(457 mm)Gas, Wood or FuelOil TerminationBASeeillustrationabove for woodWoodGasFuel OilTerminationGas, Wood or FuelOil Termination20 in. min. *(508 mm)Seeillustrationabove for woodTermination Caps Staggered HeightA Gas Termination Wood or Fuel Oil TerminationB 6 in. (152 mm) min. 20 in. (508 mm) min.Termination Caps Same Height* If using decorative cap cover(s), this distance mayneed to be increased. Refer to the installation instructionssupplied with the decorative cap cover.Multiple Chimney LocationsFigure 8.10 Multiple Chimney Locations30Heatilator • Birmingham BIR42 • 4059-308 Rev C • 07/08