Owner's Manual - At Andiron Fireplace Shop

D. Install Side Molded Brick Panel - Herringbone• If a gas line is to be installed, remove the knockouts inthe inner fi rebox and in the outer shell on the side ofyour choice. Refer to dimension drawings for location ofknockouts and Section 13.A. for gas provisions.• Do NOT remove screen rods.• Refer to Figure 11.2.• Install lower side panel, tapered edge to the front. Alignthe front edge with the front of the column (or butted tothe surround if installed).• Install two T-brackets stem down into mortar line, do nottighten.• Install upper side panel in the unit, tapered edge tothe front. Position the bottom of panel behind the T-brackets.• Install two T-brackets stem up into mortar lines, one Y-bracket on the front edge as shown. Do not tighten.• Install two Z-brackets in the mortar lines across the top.Tighten these and all previously installed brackets.• Install second side panel following the steps above.Note: Use T-brackets as templates and drill pilot holes intothe inner shell with the drill bit provided. Side panels mustbe installed fi rst.E. Install Back Molded Brick Panel - Herringbone• Refer to Figure 11.2.• Set the grate brackets in place, 26.5 in. (673 mm) centerto center.• Install the lower back panel. Center from side to side.• Install two T-brackets stem down into mortar line to holdlower back in position. Do not tighten.• Install upper back panel. Position bottom of panel behindthe previously installed T-brackets.• Install three T-brackets stem side up into mortar line, donot tighten• Install two Z-brackets in the mortar lines across the top.Tighten these and all previously installed brackets.FrontUpper SideMolded Brick PanelUpper BackMolded Brick PanelLower BackMolded Brick PanelLower SideMolded Brick PanelGrate BracketsHearth Molded Brick PanelFigure 11.2 Herringbone Molded Brick Panel38Heatilator • Birmingham BIR42 • 4059-308 Rev C • 07/08