BWH Manual (PDF) - INTRuST Neuroimaging Leadership Core

More documents

Recommendations

Info

2. Contact InformationIf you have any questions or concerns regarding MRI imaging study please contact:Mike ColemanSenior Project ManagerINTRuST Neuroimaging Leadership CoreE-mail: MJC@bwh.harvard.eduOffice: 617-525-6114Cell: 617-347-1031Jason Schneiderman, Ph.D.Neuroimaging Core Supervising Post-Doctoral FellowE-mail: jason@bwh.harvard.eduOffice: 617-525-6115Cell: 516-697-1167If you have questions regarding the scan uploading to the CNDA database please contact:Dan Marcus, Ph.D.Primary E-mail: cnda-help@cpg.wustl.eduSecondary E-mail: dmarcus@npg.wustl.eduOffice: 314-362-4562Secretary (Cathy Gezella): 314-286-0553
3. Site QualificationNote: This is background information. For all scans to be performed pleasesee sections 4-9Prior to any INTRuST subjects being scanned at a particular site, that site was required toattain INTRuST site qualification. All MRI scans will be conducted on 3T scanners. Sitequalification included two different exams. The first, being a scan on the specially designedBIRN (Biomedical Informatics Research Network) phantom with the electronically providedINTRuST sequences loaded by your local service engineer or lead technologist. Secondly,your site was asked to scan a human volunteer with the approved INTRuST sequencesloaded by your local service engineer. NLC QC reviewed the phantom and human scans forthe correct parameters, good image quality, and scanner performance. If either scan did notpass NLC QC review, your site was asked to re-scan after making the suggested changesby the NLC QC team.Qualification Phantom Scan Protocol1. Localizer2. ASSET Calibration Scan3. INTRuST suggested DWI sequence4. INTRuST suggested Structural Scan Sequence (T1)5. INTRuST suggested Susceptibility Weighted Imaging sequence6. INTRuST suggested Proton Density Scan7. INTRuST suggested T2 scan sequence8. INTRuST suggested Resting State fMRIHuman Volunteer Scan Protocol for Calibration1. Localizer2. ASSET Calibration Scan3. INTRuST suggested DWI sequence4. INTRuST suggested Structural Scan Sequence (T1)5. INTRuST suggested Susceptibility Weighted Imaging sequence6. INTRuST suggested Proton Density Scan7. INTRuST suggested T2 scan sequence8. INTRuST suggested Resting State fMRI (Subject should have eyes OPEN)After each scanning session, the DICOM images were loaded to the CNDA database usingthe INTRuST naming conventions discussed later in this manual.If you have questions regarding the site qualification scans, please contact:MJC@bwh.harvard.eduNOTE: Only one MRI scanner was qualified for INTRuST at your site. Thescanner must be used for ALL subsequent subject scans during the INTRuSTstudy. If a different MRI scanner is used, the scan will not be reimbursed, and thesubject will need to be re-scanned on the INTRuST qualified scanner.
Page 1 and 2: MRI Technical Procedures ManualUpda
Page 3 and 4: What Institutions are participating
Page 5: 1. General InformationThe purpose o
Page 9 and 10: Example of sagittal image from high
Page 11 and 12: 5.4 Subject PositioningProper subje
Page 13 and 14: Subject ID: INTRuST_023_V_###Where
Page 15 and 16: Scan Information Log (Appendix 2).7
Page 17 and 18: 8. Full MRI Scan DescriptionsNOTE:
Page 19 and 20: • Images should be collected infe
Page 21 and 22: and should fully cover the cerebell
Page 23 and 24: 8.7 Resting State fMRI Scan8.7.1 Or
Page 25: 10. Appendices10.1 MRI Pre-Screenin
Page 29 and 30: MRI Scan Information LogINTRuST - M
Page 31 and 32: Scan #7: Resting State fMRIComplete
Page 33 and 34: 10.4 INTRuST Quality Assurance Guid
Page 35 and 36: Metal Artifact: In this example the
Page 37 and 38: T2W SPECIFIC QAIf multi-coil calibr
Page 39 and 40: 10.5 Data Transfer to the CNDA Data
Page 41: Finally, in the “Additional Notes

BWH Manual (PDF) - INTRuST Neuroimaging Leadership Core

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?