You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Step 4Attach the ball end to the servo horn using the hardwareprovided with the ball end. The attachment point will be1 1 / 2-inch (38mm) from the center of the servo horn. Step 6Drill each of the locations using a drill and 3/32-inch(2.5mm) drill bit. Step 5Position the tail gear assembly on the bottom of thefuselage. Use a felt-tipped pen to mark the locations forthe two screws. Step 7Thread a #6 x 5/8-inch socket head sheet metal screw intothe holes, then remove the screw.Note: The tail gear will keep the rudderhinge in position. You will need to trim theremovable hinge pin so it is 1/4-inch (4mm)above the tail gear when it has been installed.14
Change language