Joker XL manual - Pichler

More documents

Recommendations

Info

JOCKERInstruction ManualRudder servo left sideVERTICAL INSTALLATION.Vertical stabilizer installationSee picture below.2.Mark the shape of the vertical on the leftand right side on the rudder using a felt-tippen.Mark line.1. Slide the rudder into the fuselage as sameas picture below.3.Now, remove the rudder and using amodeling knife, carefully cut just inside themarked lines and remove the film of the rudder.Just as you did with the horizontal stabilizer,make sure you only press hard enoughto cut the film, not the balsa rudder.Top side.Removecovering17
JOCKERInstruction ManualPush.Epoxy glue.HorizontalStabilizer.90ºVerticalStabilizer.C/A glue.4. Put the vertical stabilizer back inplace. Using a triangle, check to ensurethat the vertical stabilizer is aligned 90 degreeto the horizontal stabilizer.Epoxy glue.18
Page 1 and 2: PICHLERJoker XLAnleitung / ManualR/
Page 3 and 4: ASK-14 Anleitung / ManualSonderzube
Page 5 and 6: JOCKERInstruction ManualC/A glueAIL
Page 7 and 8: JOCKERInstruction ManualFLAP SERVOS
Page 9 and 10: JOCKERINSTALLING ELECTRIC MOTOR.See
Page 11 and 12: JOCKERInstruction ManualA+B EpoxyPL
Page 13 and 14: JOCKERInstruction ManualBottom side
Page 15 and 16: JOCKERInstruction ManualBottom side
Page 17: JOCKERInstruction ManualMOUNTING TH
Page 21 and 22: JOCKERInstruction Manual5) When you
Page 23 and 24: JOCKERInstruction ManualLeft wing.R

Joker XL manual - Pichler

Create successful ePaper yourself

Delete template?

Save as template?