Joker XL manual - Pichler

More documents

Recommendations

Info

JOCKERInstruction ManualC/A glue.Mark point.C/A glue.Carefully make a 90 degree bend downat the mark made. Cut off the excess wire,leaving about 20mm beyond the bend.Bend and cut.A+B EpoxyPLUS glueBend 90 degree.20mm.Push.19
JOCKERInstruction Manual5) When you are sure that everything is aaligned correctly, mix up a generous amountof 30 minute epoxy. Apply a thin layer to theslot in the mounting platform and to the verticalstabilizer mounting area. Apply epoxy tothe lower rudder hinge. Set the stabilizer inplace and re-align. Double check all of yourmeasurements once more before the epoxycures. Remove any excess epoxy using apaper towel and rubbing alcohol and hold thestabilizer in place with T-pins or masking tape.Allow the epoxy to fully cure before proceeding.RUDDER CONTROL HORN INSTALLA-TION.Rudder control horn install as same as theway of aileron control horn. Please see picturesbelow.Rudder control horn.A+B EpoxyPLUS glueC/A glue.C/A glue.Top side.Rudder controlhorn.20
Page 1 and 2: PICHLERJoker XLAnleitung / ManualR/
Page 3 and 4: ASK-14 Anleitung / ManualSonderzube
Page 5 and 6: JOCKERInstruction ManualC/A glueAIL
Page 7 and 8: JOCKERInstruction ManualFLAP SERVOS
Page 9 and 10: JOCKERINSTALLING ELECTRIC MOTOR.See
Page 11 and 12: JOCKERInstruction ManualA+B EpoxyPL
Page 13 and 14: JOCKERInstruction ManualBottom side
Page 15 and 16: JOCKERInstruction ManualBottom side
Page 17 and 18: JOCKERInstruction ManualMOUNTING TH
Page 19: JOCKERInstruction ManualPush.Epoxy
Page 23 and 24: JOCKERInstruction ManualLeft wing.R

Joker XL manual - Pichler

Create successful ePaper yourself

Delete template?

Save as template?