DOWNLOAD Manual FireStingO2 (PDF, 4 MB) - Pyro-science.com

Signal too high There might be too much ambient light on thesensor tip or the sensor spot. Avoid direct sun light exposure orstrong direct illumination with a lamp. (For advanced users:decrease the LED intensity and/or the amplification in theAdvanced Settings)Bad reference This indicates internal problems of theFireStingO2. Please contact PyroScience for support.Refer also to Troubleshooting in chapter 12.3.The adjustment of the Settings using the button Settings isdescribed in detail in chapter 6.2.The button Save Setup can be used to save the current settingsand calibration data of all channels. They can be reloaded anytimeby pressing the button Load Setup. This allows e.g. to switchbetween different laboratory setups with a single FireStingO2.This function might be also useful if different computers are usedfor the calibration and for the actual measurements. You mightcalibrate the sensors with the first computer, save theconfiguration with Save Setup. By transferring this file and alsothe oxygen meter FireStingO2 to a second computer, you can loadthere again this configuration with Load Setup giving youcalibrated sensors ready for the measurement.Save Setup and Load Setup might be also useful if e.g. a 1-channel FireStingO2 should be used repeatedly with severaloxygen sensors. Initially each sensor needs to be calibrated onlyonce and the configuration of each sensor is saved with SaveSetup. If later on a measurement should be performed with aspecific sensor, it is only necessary to load the configuration forthis sensor with Load Setup.32