Manual - LP2824 - logmaster

Adjusting the Print WidthPrint width must be calibrated when you use a roll with a different widthfrom previous media.Print width may be set by using the Set Label Width (Q) command(described in the programming guide).Adjusting the Print QualityPrint quality is influenced by the heat of the print head, the speed of themedia and the type of media you are using. Only by experimenting willyou find the optimal mix for your application.If you find that the print darkness needs to be adjusted, refer to the heatdensity (D) command (described in the programming guide).If you find that the print speed needs to be adjusted, refer to the print speed(S) command (described in the programming guide).18 980481-001A