Manual - LP2824 - logmaster

More documents

Recommendations

Info

Feed Button ModesPrinter ConditionPrinter is off.Cover is openLabels, tags orfan-fold forms areloaded.Continuous media rollis loaded.Fresh media has justbeen loaded.Printer is OFFFeed Button ActionTapping or holding the button has no result.Printer is ONTapping or holding the button has no result.Tap the button once to perform a "form feed."Hold the button to perform a "continuous feed."The printer stops at the top of the next form.Tap the button to perform a "line feed."The printer stops on the next line.Hold the button to perform a "continuous feed."The printer stops at the next line when you release the button.Tap the button to advance media. If printer fails to detect media,the platen stops turning and the status LED lights Red; if theprinter cannot detect a gap within 11 inches (27.9 cm), the platenstops turning and the status LED lights Amber.40 980481-001A
AppendixInterfacesUniversal Serial Bus (USB) ConnectorThe figure below displays the cable wiring required to use the printer’sUSB interface.PinSignal211 Vbus-N/C2 D-3 43 D+4 GroundShellShield/Drain WireFor information on the USB interface, go to the USB web site at:http://www.usb.org980481-001A 41
Page 1 and 2: Zebra ®LP 2824Desktop PrinterUser
Page 3 and 4: Proprietary StatementThis manual co
Page 5 and 6: ContentsIntroductionHello!. . . . .
Page 7 and 8: 980481-001A vii
Page 9 and 10: IntroductionThis section describes
Page 11 and 12: Inspecting the PrinterLook at the o
Page 13 and 14: Closing the printerLower the top co
Page 15 and 16: Getting StartedThis section describ
Page 17 and 18: Loading Roll MediaWhen you load med
Page 19 and 20: Using the GuidesThe guides direct t
Page 21 and 22: Media Length SensingMOVIEBefore you
Page 23 and 24: USB Interface RequirementsUniversal
Page 25 and 26: Serial CommunicationsSerial communi
Page 27 and 28: Operation & OptionsThis section hel
Page 29 and 30: Printing in Peel-ModeThe optional d
Page 31 and 32: Using the Cutter OptionPrinters tha
Page 33 and 34: MaintenanceCleaningWhen you clean t
Page 35 and 36: Platen ConsiderationsThe standard p
Page 37 and 38: Replacing the Print HeadIn the even
Page 39 and 40: Replacing the LP Print Head (Contin
Page 41 and 42: TroubleshootingWhat the Status Ligh
Page 43 and 44: Media HandlingProblemPrinting conti
Page 45 and 46: The printing does not start at the
Page 47: Resetting the Factory Default Value
Page 51 and 52: ZebraNet® PrintServer II for Ether
Page 53 and 54: Serial (RJ-11) Alternative Connecto

Manual - LP2824 - logmaster

Create successful ePaper yourself

Delete template?

Save as template?