910 aufst - Durkopp Adler AG

More documents

Recommendations

Info

3.3 Completing the table top6 5 4 3 2 1– Place the table top on a worktop upside down.– Screw the main switch 6 on the underside of the table top on theleft.– Screw the cable duct 5 tight behind the main switch 6.– Screw the cable duct 2 tight to the left of the lead-through 1.– Put the connecting lead 4 in the cable duct.– Fasten the connecting lead 4 by means of strain relief 3.7– Mount the socket kit 7.– Connect the cable wires at the mains switch to the clamps L1 andL2 (see page (8).– Connect the protective switch in the mains switch.6
8– Place the control box 8 on the underside of the table top andposition it in such a way that the side with the four sockets points tothe left (towards the thread reel holder).– Screw the control box with four screws on the punch-marked spotat the underside of the table top.27
Page 1 and 2: 910CNC-Nähanlage für freie Nahtko
Page 3 and 4: ForewordThis instruction manual is
Page 5 and 6: IndexPage:Part 2: Installation Inst
Page 7 and 8: 1. Scope of deliveryThe scope of de
Page 9: 3. Mounting the stand and the contr
Page 13 and 14: 3.5 Mounting the stand and the refe
Page 15 and 16: 3.7 Adjusting the working height122
Page 17 and 18: 4.2 Assembly of the sewing unit4 3
Page 19 and 20: 4.4 Potential compensation13 2- Fro
Page 21 and 22: 5. Connecting the plug connections
Page 23 and 24: 5.3 Wiring2In order to make it poss
Page 25 and 26: 8. Mounting the eye protection4321C
Page 27 and 28: 9.2 Oiling wicks and felt part (con
Page 29 and 30: 10. Putting into operation10.1 Inst
Page 31 and 32: 10.2 Seam programIf no seam program
Page 33 and 34: 11. Optional equipment11.1 Sewing l

910 aufst - Durkopp Adler AG

Create successful ePaper yourself

Delete template?

Save as template?