1766-RM001A-EN-P MicroLogix 1400 Programmable Controllers ...

Function Files 83General Channel Status BlockWord Bit Description5 12 Advertise 100 MB Full Duplex FlagThis bit indicates advertisement status if Auto negotiate enabled:• 0: 100 MB Full Duplex was not advertised during auto negotiation• 1: 100 MB Full Duplex was advertised during auto negotiation13 Advertise 100 MB Half Duplex FlagThis bit indicates advertisement status if Auto negotiate enabled:• 0: 100 MB Half Duplex was not advertised during auto negotiation• 1: 100 MB Half Duplex was advertised during auto negotiation14 Advertise 10 MB Full Duplex FlagThis bit indicates advertisement status if Auto negotiate enabled:• 0: 10 MB Full Duplex was not advertised during auto negotiation• 1: 10 MB Full Duplex was advertised during auto negotiation15 Configuration End FlagThis bit is set (1) when the Ethernet boot-up sequence is completed, including IP address, gateway address, subnetmask and etc.6…8 - Ethernet Hardware Address (6-byte string)A unique Ethernet hardware address assigned to this processor.9…10 - IP Address (in network byte order)Internet address that is specified for this processor.11…12 - Subnet Mask (in network byte order)Subnet mask that is specified for this processor13…14 - Gateway Address (in network byte order)Gateway address that is specified for this processor15…16 - Broadcast Address (in network byte order)NOT SUPPORTED AT THIS TIME. The Broadcast Address is used in sending multicast messages. A Broadcast Addressof all zeros indicates that no broadcast address was configured. In this case, the network code chooses a validbroadcast address when needed for that current subnet.17…18 - Primary Name Server(in network byte order)Primary Name Server that is specified for this processor.19…20 - Secondary Name Server(in network byte order)Secondary Name Server that is specified for this processor.21…52 - Default Domain NameDefault domain name that is specified for this processor.Publication 1766-RM001A-EN-P - October 2008