SERVICE MANUAL - Nexo

NXAMP4x4b-3) Then fasten these wires with a cord holder asshown in the figure.b-4) Fasten these wires (WM04880 x 2, WK16820 x 2)with a cord holder.b-5) Fasten these wires (WN52520 x 2, WK16820 x 2)with a cord holder (2 places).b-6) Fasten these wires (WN52520, WK16820) with acord holder (1 place).* Bend wire (WN52520) once.b-7) Fasten these wires (WN52520 x 2, WM04880 x 2)with a cord holder (2 places).b-8) Fasten these wires (WN52520, WM04880) by wireharness Tie (1 place).* Bend wire (WN52520) once.c) Connect the wire (WM04880) to connector (CN306) ofthe PSANHA circuit board. Connect the wire (WK16820)to the connector (CN317) of the PSANHB circuit board.Fasten these wires (WM04880, WK16820) with a cordholder to the hexagonal spacer as shown in the figure.(Pass the wires to the PA unit side of a hexagonalspacer)d) Connect the wire (WK14210) of the PA unit (CH4) to theconnector (CN315) of the PSANHB circuit board. (Drawthe Black tube to the PA unit side.)Pull the wire (WK14210) from PA unit to the direction ofT301 and fasten these wires (WK14200, WK14210) witha cord holder. Before fastening, pull the wire (WK14200)toward the front panel side in advance. b-4)b-7)b-3)b-7)b-5)b-3)b-5)b-6)b-8)d) c)c)Fig. 24 15