SERVICE MANUAL - Nexo

NXAMP4x4■ OVERALL ASSEMBLY WIRING This product has various cables (wires and connectorassemblies) inside. To prevent touching component tothe cables and/or connection mistake, perform the cableconnection and fixing cables according to the followinginstructions referring the wiring diagram, P3 of the circuitdiagram.Notice: Since the following pictures are taken of thepreproduction product, they may differ from thecommodity products in detail. However, the wiringand so on is not so differ between them. So, referonly to wiring and so on. 1. Wiring of the PN-AN circuit board1) Process the PN FFC assembly (WR37010). (Fig. 1, 2)2) Connect the PN FFC assembly (WR37010) to the PN-AN circuit board. (Fig. 3)3) Install the PN-AN circuit board to the front panel. [635]115 ±1 mm90˚90˚25 ±1 mmFix the bent part with adhesive tape [635].(Attach it through the center of FFC.) Fig. 1 Fig. 2 Fig. 3 * For details of wiring in the enclosure, refer to step “13.Method of Fixing PN FFC Assembly”. 7