Model 5H Dual Control <strong>Switch</strong> Machinewith Biased-Neutral Controller<strong>Switch</strong> <strong>Products</strong>features> Point DetectorAn over-and-locked type circuit controllerwith two normal, two reverse, two shuntand two motor-control contacts. The normaland reverse contacts check and indicatewhen the switch points are within theproper distance of the stock rail and arelocked. The motor control contacts controlthe motor operating circuit in conjunctionwith the biased-neutral controller.> Biased-Neutral ControllerThe machine has two biased neutral,mechanically interlocked contactors,a blocking rectifier and an overload relay.Each contactor has one dependent, frontbackcontact with a permanent magnetblowout (arc suppression). A snubbingcontact provides dynamic motor braking atthe end of the stroke. The magneticstructure prohibits armature operationuntil voltage of the proper polarity is appliedacross the coils.> HeatersProvided in the motor, controller and pointdetector compartments.Model 5H <strong>Switch</strong> Machine installed at customer location> Removable Hand CrankAvailable for maintenance and emergency use.An automatic cut-out contact, with a latch-outfeature and manual reset, protects the operator.> Overload Friction ClutchAbsorbs shocks encountered in switchoperation. It is factory adjusted to slipwhen the motor operating current is from12–14 Ampere for 110 Volt machines, and18–20 Ampere for 24 Volt machines.> Rugged MotorProvides long, reliable service. It has series,split connected, epoxy-coated, insulatedfield coils and an epoxy-coated armature.Dynamic snubbing limits motor overrun atthe end of the stroke, and a simplemagnetic detent holding device then locksthe motor armature. Magnetic holding isfrictionless and virtually maintenance-free.> Dual Control MechanismPermits either power or hand-throw operation.©2011 <strong>Alstom</strong> Signaling Inc. www.alstomsignalingsolutions.com 101
Model 5H Dual Control <strong>Switch</strong> Machinewith Biased-Neutral Controller<strong>Switch</strong> <strong>Products</strong>SpecificationsDataApplicationsValueSingle <strong>Switch</strong>, Single-slip <strong>Switch</strong>, Double-slip <strong>Switch</strong>, Derail, Movable Point FrogMounting Requirements requires only two ties for mounting; Meets requirements of AAR Load Curve 1457ThrustWeightMotor Typemaximum rated thrust 2,500 lbs. ( 1,136.7 kg)uncrated 1065 lbs. (484.1 kg)Motor Voltage 110Vdc at ± 20%, 24Vdc at ± 20%Operating TimeClutch SettingContactsDynamic Snubbing CircuitControl SchemeThrow Bar StrokeHand CrankFrost ProtectionSeries-wound DC motor; Magnetic detent holds motor against vibration andstray electrical currents at end of stroke3 seconds for 110 Volt machines, 8-10 seconds for 24 Volt machines12-14 Amps for 110 Volt machines, 18-20 Amps for 24 Volt machinesprovided for lock rod, point detector rod, and over-and-locked in normal and reverse positionsthrough contacts in the point detector. Point detector contacts: 2 normal, 2 reverse,2 motor control, 2 shunt contacts. Motor control contacts carry and break motor current directly4-wire control, 10 or 24Vdc control voltage6.0 Inches (15.2 cm)option for maintenance and emergency use; with automatic cutout contact and latch-outfeature to protect operatoroptional 110 Volt heaters for motor, controller and contact compartments; If heaters are notused, a frost shield and felt commutator cover should be installed in motor; The point detectorcontacts feature a long wipe to help prevent frost buildup on the contactsOrdering Information - Model 5H - Right and Left Hand LayoutsLock Rod Det. Rod Motor Clutch Control Ordering # PriceRH Wide-Notch Single <strong>Switch</strong> 24 Volt 24 Volt Dual, 4-wire 110 or 24VDC 54505-011-33 $27,995.00Threaded EndR/LH Wide-Notch Single <strong>Switch</strong> 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-20 $27,995.00Threaded EndR/LH Nar.-Notch Single <strong>Switch</strong> 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-30 $27,995.00Threaded EndR/LH Wide-Notch Single <strong>Switch</strong> 24 Volt 24 Volt Dual, 4-wire 110 or 24VDC 54505-011-34 $27,995.00Threaded EndLH Narrow-Notch Single <strong>Switch</strong> 24 Volt 24 Volt Dual, 4-wire 110 or 24VDC 54505-011-42 $27,995.00Threaded EndR/LH Wide-Notch Single <strong>Switch</strong> 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-21 $27,995.00Threaded EndR/LH Nar.-Notch Single <strong>Switch</strong> 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-31 $27,995.00Threaded EndLH Wide-Notch Movable Point 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-23 $27,995.00Threaded End FrogLH Narrow-Notch Single <strong>Switch</strong> 110 Volt 110 Volt Dual, 4-wire 110 or 24VDC 54505-015-48 $27,995.00Spade EndHand Crank sold separately, please contact the <strong>Alstom</strong> Customer Service Center 1-800-717-4477.102CALL 800.717.4477 • FAX 585.274.8777