EXSULATION® S5000 Mineral Wool Slab Non Combustible ... - Dryvit

Exsulation® S5000Notes:EXS.0.0.0348" typ.Approved mechanicalfastener and plate24" typ.Fixing in centreMineral woolinsulation slab1. Fixings are to penetrateconcrete by no less than 1inch or in accordance withfastener's specs.2. Additional fasteners to beinstalled at corners andother system terminations(maximum 12" on centre).3. Step 2 occurs followingapplication of basecoat andreinforcement mesh.4. It is recommended topuncture mesh and basecoat at fastener locationprior to installation. This willminimize "pull in" andsurface deformation.MECHANICAL FIXINGS - Step 15. Fasteners may be installedwhile initial mesh andbasecoat application is stillwet.12" typ.12" typ.6. Fasteners on outside ofmesh should be spottedprior to the application of anadditional basecoat overthe entire surface. Morecoats may be required toachieve flat surface.Fixing in centreBasecoat24" typ.MECHANICAL FIXINGS - Step 2R-002-07-08Mechanical Fixing PatternsDRYVIT SYSTEMS CANADA129 Ringwood Drive PO Box 1268Stouffville, Ontario L4A 8A2800-263-3308www.dryvit.com®The architecture, engineering and design of the project using the Dryvit products is theresponsibility of the project's design professional. All systems must comply with localbuilding codes and standards. This detail is for general information and guidance onlyand Dryvit Systems Canada specifically disclaims any liability for the use of this detailand/or for the architecture, design, engineering or workmanship of any project. Thedesign professional determines, at its sole discretion, whether this detail or a functionallyequivalent alternative is best suitedfor the project. Use of a functionally equivalent detaildoes not violate Dryvit's warranty. This detail is subject to change without notice.Contact Dryvit Systems Canada to ensure you have the most recent version.