EXSULATION® S5000 Mineral Wool Slab Non Combustible ... - Dryvit

Exsulation® S5000EXS.0.0.05Dryvit Drainage Strip set indabs of AP AdhesiveApproved mechanical fixingDryvit AquaFlash® meshembedded in Dryvit AquaFlashLiquid lapped over window flangeSee Protection of Rough Openingas per EXS.0.0.06 and EXS.0.0.07Approved substrateDryvit water-resistive barrier coatingDryvit adhesive in vertical notched trowelconfiguration applied over secondary barrierMineral wool insulation slab notched to accommodateDrainage Strip, flashing, and AquaFlash.Dryvit reinforcing mesh embedded in base coatDryvit finishWrap Dryvit Detail Mesh 63.5 mm (2 1 2")min. at backside of insulation slabDryvit Demandit or Color Prime onsurface(s) to receive sealantDryvit compatible sealant with closed cell backer-rodand weep tubes every 600 mm (24"), by others19 mm (3/4") min.Provide air seal, by others,around interior of windowper window manufacturer'srequirementsWindow integral flashingWrap Dryvit Detail Mesh 63.5 mm (2 1 2")min. at backside of insulation slabDryvit compatible sealant, by othersDryvit AquaFlash SystemDryvit Demandit or Color Prime onsurface(s) to receive sealant19 mm (3/4") min.BY OTHERSDRYVIT EXSULATIONS5000 SYSTEMNotes:1. Dryvit recommends that ground floorapplications and all facades exposed toabnormal stress, high traffic, or deliberateimpact have the base coat reinforced withPanzer® 15 or 20 mesh prior to Standard Plusmesh. Location of high impact zones should beindicated on contract drawings.2. Additional head flashing may be necessary forwindows that are not self flashing.Sill pan flashing, by othersDryvit water-resistivebarrier coatingDryvit AquaFlashTransition flashing3. Install Mechanical Fixings as per EXS.0.0.03. Drainable Sill OptionR-002-07-08Head/Sill for Self Flashing Window OptionsDRYVIT SYSTEMS CANADA129 Ringwood Drive PO Box 1268Stouffville, Ontario L4A 8A2800-263-3308www.dryvit.com®The architecture, engineering and design of the project using the Dryvit products is theresponsibility of the project's design professional. All systems must comply with localbuilding codes and standards. This detail is for general information and guidance onlyand Dryvit Systems Canada specifically disclaims any liability for the use of this detailand/or for the architecture, design, engineering or workmanship of any project. Thedesign professional determines, at its sole discretion, whether this detail or a functionallyequivalent alternative is best suitedfor the project. Use of a functionally equivalent detaildoes not violate Dryvit's warranty. This detail is subject to change without notice.Contact Dryvit Systems Canada to ensure you have the most recent version.