Image to Finite Element Mesh: An End to End Workflow - 3D Slicer

More documents

Recommendations

Info

Conclusion• It is now possible to perform end to endprocessing from source imagery all the waythrough Finite Element mesh generation, meshanalysis, and mesh optimization using Slicer3• Volumetric meshes for objects can be createdthrough a simple, intuitive process• Any Slicer3 model can be imported to start themesh generation processNational Alliance for Medical Image Computinghttp://na-mic.org © 2010, ARR
Acknowledgments• National Alliance for Medical Image ComputingNIH U54EB005149National Institute of Biomedical Imaging and BioengineeringR21EB001501 and R01EB005973Musculoskeletal Imaging Modeling and EXperimentation (MIMX)LaboratoryThe University of IowaNational Alliance for Medical Image Computinghttp://na-mic.org © 2010, ARR
Page 1 and 2: NA-MICNational Alliance for Medical
Page 3 and 4: Pre-requisites• This tutorial ass
Page 5 and 6: Material• This tutorial requires
Page 7 and 8: Material• Interactive screencasts
Page 9 and 10: OverviewIn this tutorial, we will
Page 11 and 12: Creating a Labelmap• A label map
Page 13 and 14: Creating a Label map• Select the
Page 15 and 16: Smoothing the Label• After editin
Page 17 and 18: Smooth Even More?• The Surface To
Page 19 and 20: Importing a Surface Model• Any Mo
Page 21 and 22: Creating a Building Block1. Select
Page 24 and 25: Creating a Mesh• The surface impo
Page 26 and 27: Assigning Mesh Seeds (2)3. Select t
Page 28 and 29: Check Mesh Quality• Once mesh cre
Page 30 and 31: Checking Mesh Quality (2)3. Select
Page 32 and 33: Improving Mesh Quality1. Select the
Page 34 and 35: After Mesh Generation• After mesh
Page 36 and 37: Material Properties (2)Element Set
Page 38 and 39: Assigning Material Properties• Vi
Page 40 and 41: Load and Boundary Conditions (2)5.
Page 42 and 43: Load and Boundary Conditions (4)14.
Page 44 and 45: • Save the FE Mesh1. Select Save

Image to Finite Element Mesh: An End to End Workflow - 3D Slicer

Create successful ePaper yourself

Delete template?

Save as template?