request for letters of interest - Broward Sheriff's Office

TECHNICAL PROVISIONS PAGE 31SECTION 3.7WARRANTIES AND BONDSPART I - GENERAL3.7.1. SUMMARY3.7.1.1. This Section specifies general administrative and procedural requirements forwarranties and bonds required by the Agreement, including manufacturer’sstandard warranties on products and special warranties.3.7.1.2. Refer to the Agreement for terms of the Contractor’s special warranty ofworkmanship and materials.3.7.1.3. General closeout requirements are included in Section 3.6, Project Closeout.3.7.1.4. Disclaimers and Limitations: Manufacturer’s disclaimers and limitations onproduct warranties do not relieve the Contractor or the warranty on the workthat incorporates the products, nor does it relieve suppliers, manufacturers,and subcontractors required to countersign special warranties with theContractor.3.7.1.5. DEFINITIONS3.7.1.5.1. Standard Product Warranties are preprinted written warrantiespublished by individual manufacturers for particular products andare specifically endorsed by the manufacturer to BSO.3.7.1.5.2. Special Warranties are written warranties required or incorporatedin the Contract Documents, either to extend time limits providedby standard warranties or to provide greater rights for BSO.3.7.1.6. WARRANTY REQUIREMENTS3.7.1.6.1. Related Damages and Losses: When correcting warranted workthat has failed, remove and replace other work that has beendamaged as a result of such failure or that must be removed andreplaced to provide access for correction of warranted work.3.7.1.6.2. Reinstatement of Warranty: When work covered by a warranty