Opcode OMS Version 2.3 User Manual from 1996 - House of Synth

More documents

Recommendations

Info

Click the M1 MIDI Out arrow to disconnect it.MIDI Out is disconnectedYour Studio Setup document now accurately reflects the cabling in your actualMIDI studio.THRU EXAMPLE 2Assume you have two MIDI devices connected as shown inFigure 24.To MacFigure 24: Alternative MIDI Daisy ChainTo create this connection in a Studio Setup document: Drag the M1 icon on top of the K2000 icon, then disconnect the K2000’s MIDIoutput. Click the M1 icon to select it (highlighting it). Choose Studio>Different In/Out Ports.OMS Setup creates a MIDI loop with a MIDI plug.MIDI LoopMIDI PlugCh 5: Special Studio Setup Techniques - 34 - OMS 2.3 for Macintosh
Drag the MIDI plug onto the MIDI interface icon.... over the Interface iconDrag this MIDI plug...OMS Setup creates the Studio Setup document shown in Figure 25, which nowaccurately reflects the MIDI connections shown in Figure 24.Figure 25: Correct Studio Setup DocumentUSING MIDI MERGERSA MIDI merger combines the MIDI outputs of two different MIDIdevices into a single MIDI output.For example, assume your studio has a standard MIDI interface andthat you have two MIDI keyboard synthesizers. Without a MIDImerger, you could connect only one of your keyboard’s MIDI outputsto your computer.To MacFigure 26: M1 cannot be used as a MIDI ControllerThis results in the following Studio Setup document:Ch 5: Special Studio Setup Techniques - 35 - OMS 2.3 for Macintosh
Page 5 and 6: MANUALCONVENTIONSThis manual uses a
Page 7 and 8: If you are updating from an older v
Page 9 and 10: DriverFunctionEnables OMS to work w
Page 11 and 12: FileFunctionA component of OMS that
Page 13 and 14: CREATING YOUR FIRST STUDIO SETUP DO
Page 15 and 16: SEARCHING FORMIDI DEVICESIf you’v
Page 18 and 19: ANATOMY OF THE STUDIO SETUP DOCUMEN
Page 20 and 21: QuickTime Music DriverThis driver i
Page 22 and 23: Select the appropriate clock freque
Page 24 and 25: Keep the MacProteus MIDI Manager dr
Page 26 and 27: DEFININGMANUFACTURERAND MODELYou’
Page 28 and 29: MIDI Synchronization check boxesChe
Page 30 and 31: Choose Edit>Delete.OMS Setup remove
Page 32 and 33: CONNECTINGDEVICES TO AMIDI INTERFAC
Page 34 and 35: The actual MIDI studio has the K200
Page 38 and 39: By using a MIDI merger, you could c
Page 40 and 41: ADDING A MIDIPATCHBAY TOTHE STUDIO
Page 42 and 43: MIDI Port NumericalsFigure 33: Stud
Page 44 and 45: Click the On radio button to turn o

Opcode OMS Version 2.3 User Manual from 1996 - House of Synth

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?