Cables for data transmission in industrial automation - LEONI

66Fast Assemblywww.leoni-industrial-projects.comStripping tools for fast assemblyStripping Tool for PROFIBUS, FOUNDATION TM Fieldbusand PROFINET (Industrial Ethernet)For assembly work with stripping tools LEONI created FA FastAssembly bus cables, marked with FA.Area of Application:This stripping tool is solely intended for use as described inthese instructions. Other uses may result in accidents, severepersonal injury, or damage to the tool and/or cable. For yourown safety, use only the Connectors/Glands or additionaldevices recommended in these instructions or by the manufacturer.Data of the stripping tool:■■Length: 100 mm■■Weight: 65 g■■Preset cutting depth for ES-Bus Cables■■Exchangeable cassette with require blade intervals■■Blade cassette can be used from two sidesThe adjusting screws have already been adjusted for the bussystem specified on the stripping tool. Protect yourself fromlive parts do not work on live parts. Keep live parts awayfrom the area in which you are working or cover themappropriately.To avoid personal injury or damage to the tool or cable, ensurethat repairs are carried out by authorised personnel only.Preadjusted stripping toolDo not change the setting of the adjusting screws. The adjustingscrews have already been adjusted for the bus systemspecified on the stripping tool.Exchanging the blade cassetteWe recommend using a small slotted screwdriver to openthe blade cassette compartment, especially if the tool is new.Warning: risk of injury.Both sides of the PROFIBUS blade cassette can be used. Removethe cartridge, rotate it vertically by 180° and then put itback into place. When working with PVC sheaths, the cartridgeshould be replaced after it has been used approx. 3,000 times(2 x 1,500). In the case of PUR sheaths, the cassette must be replacedafter it has been used 300 times (2 x 150). Replacementcassettes can be purchased from your LEONI distributor.