ONE300 Installation Manual - OneAccess extranet

More documents

Recommendations

Info

5 InstallationAlways unplug the power AC cable before any hardware maintenanceoperation.This chapter describes assembling/disassembling operations for optional modules.The user should be aware that the router software auto-detects on-board modulesand interfaces.All vacant slots of the rear panel must be obstructed with suitable faceplatesin order to guarantee the respect of the EMC standards as defined inChapter 7. Directives and Standard5.1 Opening the Chassis1 Unlock the 2 screws located on each side of the cover,2 Remove the cover.24ONE300 – Installation Manual
5.2 Extension BoardThe installation or exchange of a daughter board requires remove the cover (seechapter 4.1).Figure 4. Removal-Installation of an Extension Board5.2.1 Removal of an extension board• Unscrew and remove the cover,• Unscrew the fixing stand of the module on the motherboard,• Loosen the module from the motherboard connection connector,• Loosen the module from the motherboard connector by gently separating themotherboard and the module.5.2.2 Installation of an extension board• Unscrew and remove the cover,• Remove the protective faceplate of the slot,• Position the module so that the module metallic faceplate fits in the placemade available by the removal of the faceplate,• Lower the module while aligning the module with the motherboard connector,• Plug the module into the motherboard connector.• Screw the fixing standONE300 – Installation Manual25
Page 1 and 2: ONE300Installation ManualVersion BA
Page 3 and 4: How to Read this ManualThe present
Page 5 and 6: 1 Safety InstructionsThe following
Page 7 and 8: 2 Directives and Standards2.1 Decla
Page 9 and 10: 3 Router Description3.1 Hardware De
Page 11 and 12: 3.3 Rear PanelThis section details
Page 13 and 14: 3.3.2 Configuration with 1 PRIThe i
Page 15 and 16: 4 Interface Description4.1 G.SHDSL
Page 17 and 18: 4.3 LAN 10/100 Mbps interface (ETHE
Page 19 and 20: 4.5 ISDN PRI Interface (PRI)This in
Page 21 and 22: The drawing below presents the posi
Page 23: Configuration with impedance adapta
Page 27 and 28: 6 Power-upTo power up the device, a
Page 29 and 30: 8 Directives and Standards8.1 Decla
Page 31 and 32: TelecomITU-T K21 on G.SHDSL(2003-07

ONE300 Installation Manual - OneAccess extranet

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?