ONE300 Installation Manual - OneAccess extranet

More documents

Recommendations

Info

2.2 StandardsThe ONE300 is designed in conformity with the standards listed hereafter, providedthat the basic housing, modules, interface boards and installation kits are mountedas recommended in the corresponding installation manual(s).SécuritéEN60950-1: 2001, FirstEditionSafety of information technology equipment, including electricalbusiness equipment.Environment :Climatic, physico chemical, mechanic, packingETS 300 019-1 (95) Environmental conditions and environmental testing fortelecommunication equipmentIn use : Temperature ControlledTest specification :- class T3.1 (normal)- class T3.1 (exceptionnal)Part 1, Classification of environmental conditionsStorage: partly temperature controlledT1.1 Part 2, Specification of environmental testTransportation: careful TransportationT2.3Electromagnetic Compatibility, immunityETSI EN 301 489-17 V1.2.1(2002-08)ETSI EN 300 328 V1.7.1ETSI EN 300 386 V.1.3.3(2005-04)Waste Electrical and Electronic Equipment2002/96/ECElectroMagnetic Compatibility (EMC) standard for radio equipmentand services.Part 17: Specific conditions for 2,4 GHz wideband transmissionsystems and 5 GHz high performance RLAN equipment.Data transmission equipment operating in the 2,4 GHz ISM bandand using wide band modulation techniques;Harmonized EN covering essential requirements under article 3.2of the R&TTE Directive.Telecommunication network equipment;ElectroMagnetic Compatibility (EMC) requirements.Le ONE300 respecte la directive européenne sur l’élimination desdéchets issus des équipements électriques et électroniques.Restricted use of Hazardous Substances (RoHS)2002/95/ECThe ONE300 respects the European directive on the restricted useof Hazardous Substances in electric and electronic equipment.8ONE300 – Installation Manual
3 Router Description3.1 Hardware DescriptionThis section details the various types of services offered by the ONE300. Thedescribed configurations are the maximum configurations for the motherboard andthe extension modules. Other configurations can be derived by under-equipment.Indeed, the ONE300 can have fewer interfaces compared to those presented below.The acronyms mentioned in bold between brackets locate markings of the interfacesback panel.3.1.1 Motherboard InterfaceThe ONE300 motherboard is equipped with the following interfaces. The interfacemarking is indicated in bold and between brackets.• 1 G.SHDSL access network (2 or 4 wires) or IMA SHDSL (8 wires) (SHDSL),• 1 Console port (CONSOLE),• 1 Managed switch 4 ports (SWITCH).• 1 LAN access 10/100 Mbps (ETHERNET),Optional Interfaces factory mounted:• 1 PRI Interface T2 (PRI),• WLAN 802.11b/g with 2 antennas (managed by the method « antennadiversity »).3.1.2 Extension ModulesAdditional services are available in option on the daughter-board described below.3.1.2.1 8 BRI boardThis board in its complete configuration has the following interfaces. The interfacemarking is indicated in bold and between brackets.• 8 ISDN Basic Rate Interfaces S0/T0 configurable TE or NT mode (ISDNBRI).ONE300 – Installation Manual9
Page 1 and 2: ONE300Installation ManualVersion BA
Page 3 and 4: How to Read this ManualThe present
Page 5 and 6: 1 Safety InstructionsThe following
Page 7: 2 Directives and Standards2.1 Decla
Page 11 and 12: 3.3 Rear PanelThis section details
Page 13 and 14: 3.3.2 Configuration with 1 PRIThe i
Page 15 and 16: 4 Interface Description4.1 G.SHDSL
Page 17 and 18: 4.3 LAN 10/100 Mbps interface (ETHE
Page 19 and 20: 4.5 ISDN PRI Interface (PRI)This in
Page 21 and 22: The drawing below presents the posi
Page 23 and 24: Configuration with impedance adapta
Page 25 and 26: 5.2 Extension BoardThe installation
Page 27 and 28: 6 Power-upTo power up the device, a
Page 29 and 30: 8 Directives and Standards8.1 Decla
Page 31 and 32: TelecomITU-T K21 on G.SHDSL(2003-07

ONE300 Installation Manual - OneAccess extranet

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?