Pliers

AUTOACATest & Measurement Line AccessoriesTest & MeasurementLine Splitter• Assists in measuring the currentdraw of a connected load up to15A without splitting the load'spower cord.Voltmeter input jacksProvides X10 mode and X1 mode.• Designed for use with Klein ToolsTest & Measurement Line(CL100, CL200, CL1000, CL1100,CL2000, CL2100, CL2500, CL3200).• Works with many othermanufacturers' clamp meters.NEW!69400WARNINGS:• Do NOT use with loads greater than 15A.• Risk of electric shock and burn. Contact with live circuits could result indeath or serious injury.• Do not use if Line Splitter appears damaged. If in doubt, replace LineSplitter. Do NOT use Line Splitter if wet. For indoors use only.Cat. No. Overall Length Width Weight (oz.)69400 6.2" (157 mm) 2.2" (558 mm) 3.9 (with batteries)ReplacementTest Lead SetPair of universal test leads includes alligator clips.• Fits lead storage compartment on theMM1000, MM2000, CL1000, CL1100, CL2000, CL2100,CL2500, CL3100, and CL3200.69410• Also compatible with MM100, MM200, CL100, CL200,and CL3000.Cat. No. Description Weight (oz.)69410 universal test lead set w/ alligator clips 3.2 (90.7 g)Magnetic HangerCL200Carrying Case• Constructed of 600 DenierNylon with a heavy-dutyPVC zipper and Zinc Alloyzipper tag.• Convenient storage formost Klein test andmeasurement products.• For use withMM1000 and MM2000Electrician's Multimeters.• Clips securely into backof rubber boot.• Strong magnet attachessecurely to metalsurfaces forhands-free use.6919069401Cat. No. Overall Size Weight (oz.)69401 3-1/2" (89 mm) W x 9-1/2" (235 mm) H x 2 (50 mm)" D 2.5Cat. No. Description Weight (oz.)69190 magnetic hanger for electrician's multimeters 1.1 (31.2 g)All dimensions are in inches and (millimeters).306WARNINGS:To ensure safe operation and service of the tester, follow these instructions. Failure to observe these warnings can result in severe injury or death.• Before each use, verify meter operation by measuring a known voltage or current.• Never use the meter on a circuit with voltages that exceed the category based rating of this meter.• Do not use the meter during electrical storms, or in wet weather.• Do not use the meter or test leads if they appear to be damaged.• Ensure meter leads are fully seated, and keep fingers away from the metal probe contacts when making measurements.• Do not open the meter to replace batteries while the probes are connected.• Use caution when working with voltages above 60V DC, or 25V AC RMS. Such voltages pose a shock hazard.• To avoid false readings that can lead to electrical shock, replace batteries if a low battery indicator appears.• Unless measuring voltage or current, shut off and lock out power before measuring resistance or capacitance.• Always adhere to local and national safety codes. Use individual protective equipment to prevent shock and arc blast injury where hazardous live conductors are exposed.All dimensions are in inches and (millimeters).See end of section for important safety information regarding the test and measurement line.