Installation and Assembly - Universal Articulating

More documents

Recommendations

Info

WARNING• If you are uncertain that product is properly installed, call customer care.22-1Note: There are five mounting positions. Thecenter position is shown (right). Slide washer (J)over wall support arm axle (D). Next, insert plasticcap (N) into axle. Then, insert holding pin (M) intoaxle. See detail 1.Place arm assembly (C) with washer (J) into wallplate (A). Insert axle assembly shown in detail 1through wall plate (A), arm assembly (C), andwasher (J). Lock axle in place by aligning holdingpin (M) with notches shown in detail 2.ANJDMDETAIL 12-2Insert socket cap screw (K) into hole at bottom ofwall support arm axle (D) as shown in detail 3.Tighten screw using 9/64" allen wrench (Q).Note: Fit of axle (D) into wall plate (A) and armassembly (C) will be tight. Gently tap into placewith a hammer if necessary.CNOTCHDETAIL 2JKDDETAIL 333-1Snap four cable management clips (R) into top or bottom of arm assembly (C) as shown. Cable ties (S) are usedwith clips for cord management.Slide one mesh sleeve (T) over each cable. Use cable ties (S) to tighten mesh sleeves to cables.RTCS8 of 13 ISSUED: 06-05-06 SHEET #: 202-9141-3 08-17-06
44-1Attach two pieces of vinyl trim (E) to wall plate (A). Next, attach one piece of vinyl trim to bottom of swivel box on armassembly (C).Insert one finishing cap (L) into each unused hole of wall plate (A).LASWIVEL BOXCE5Insert and tape carriage bolt (I) into top hole of pitch-roll assembly (B). Attach tilt-roll assembly to adapterbracket (AA) with four M10 socket screws (F). Tighten screws using 6 mm allen wrench (U).CAUTION• Do not overtighten screws! Overtightening may hinderroll option.AAIBF9 of 13 ISSUED: 06-05-06 SHEET #: 202-9141-3 08-17-06
Page 1 and 2: Installation and Assembly - Univers
Page 3 and 4: Wall Mount Parts ListRTPLA 60-SBefo
Page 5 and 6: Security Adapter Bracket FastenersM
Page 7: Installation to Concrete WallWARNIN
Page 11 and 12: Installing Adapter Brackets7Refer t

Installation and Assembly - Universal Articulating

Create successful ePaper yourself

Delete template?

Save as template?