TDR-Manual 2009 - Henseleit Helicopters

Table of ContentsSafety instructions: p. 3TD- Rigid: Description and technical data p. 4Parts list: List of all parts of the single assembly groups p. 7Start: Operating intructions for the interactive animations p. 8(the interactive 3D drawings have been animated by Oliver Möhring)Introduction: Important! General information for the assembly p. 9Chapter I Main rotor ( Assembly group 1 ) p. 10Chapter II Rotor shaft unit ( Assembly group 4 ) p. 12Chapter III Intermediate shaft unit ( Assembly group 5 ) p. 13Chapter IV Tail boom ( Assembly group 8 ) p. 14Chapter V Chassis ( Assembly group 2 ) p. 15Pre-assembly of the upper part of the chassis p. 15Adjustment of the gear play p. 16Pre-assembly of the lower part of the chassis p. 17Assembly of the upper part to the lower part of the chassis p. 18Chapter VI RC preparation ( Servos ) p. 19Chapter VII Control and servo assembly ( Assembly group 6 ) p. 20Chapter VIII Assembly of the electric motor ( Assembly group 7 ) p. 23Chapter IX Tail gear ( Assembly group 9 ) p. 24Chapter X Assembly and struts of the tail boom ( Assembly group 8 ) p. 30Chapter XI Assembly of the electronic parts ( V- Stabi / receiver / controller / batteries ) p. 32Chapter XII V-Stabi Connection and programmation (Author: Matt Finke) p. 36Chapter XIII Final tasks ( Canopy etc. ) p. 47Chapter XIV Adjustments ( V-Stabi, rotor blades, throttle curves etc. ) p. 48Chapter XV Directions for initial flight ( RPM, operating limits, hints etc. ) p. 51Chapter XVI Maintenance / spare parts p. 532