Instruction Manual
CAD-PD Power Drive - Capital Doorworks
CAD-PD Power Drive - Capital Doorworks
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ACCESSORIES<br />
3.3 - Safety Infra-Red Beam - Part No 062153<br />
Fig. 21<br />
Note: This opener is only compatible with<br />
B&D’s Transmitter/Receiver type IR Beam<br />
(Order Code: 062153).<br />
For ADDITIONAL SAFETY protection we STRONGLY<br />
recommend the fitting of a Safety Infra-Red Beam. In most<br />
countries Safety Beams are mandatory on all garage doors<br />
fitted with automatic openers. For a small additional outlay<br />
B&D recommends that Safety Infra-Red Beams be installed<br />
with the automatic opener ensuring additional safety and<br />
peace of mind.<br />
Locate the IR Beam in a strategic location within doorway.<br />
We recommend 150mm above the floor level and as close<br />
as possible to the door opening, inside the garage. Make<br />
sure to align the beams correctly. Follow the manual<br />
supplied with the IR Beam. Twist the wires from both<br />
transmitter and receiver together before connecting to the<br />
terminal block as per Fig. 21.<br />
WARNING: When using Auto Close Mode and IR beams,<br />
the doorway must be clear of all obstructions and persons at<br />
all times. The location of the beam and manner in which it is<br />
installed might not give safety protection at all times. Check<br />
to make sure that the height of the beam and type used give<br />
maximum protection possible.<br />
WHITE FROM TX & RX<br />
WHITE W/BLACK FROM TX & RX<br />
GND<br />
IR BEAM<br />
30V PWR<br />
OPERATE<br />
CLS OUT<br />
AUX OUT<br />
Fig. 22<br />
Note: For the Safety IR Beam to be<br />
recognised by the controller, it must be<br />
installed and connected before the travel<br />
limits are set. Refer to Step - 7 on Page 12.<br />
3.4 - Wired Wall Switch/Electric Key Switch<br />
A wired wall switch or electric key switch can be connected<br />
to the opener as an alternative to using the remote control<br />
transmitter. The electric key switch (shown in Fig. 22<br />
- B&D Part No 059009) also acts as an external release<br />
mechanism which is ideal if your garage does not have a<br />
pedestrian door.<br />
To connect the switch to the opener’s terminal block refer to<br />
Fig. 22.<br />
The switch behaves just like a remote control transmitter:<br />
each turn of the key will cycle through an open - stop - close<br />
function.<br />
Note: Please refer to the Electric Key Switch/Release unit’s<br />
instruction sheet for installation procedure.<br />
GND<br />
IR BEAM<br />
30V PWR<br />
OPERATE<br />
CLS OUT<br />
AUX OUT<br />
©Copyright 2006 B&D Doors<br />
- 18 -<br />
P/N: 05xxx