Amplifiers
digital music amplifiers - Paso Sound Products
digital music amplifiers - Paso Sound Products
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PROFESSIONAL AUDIO & SOUND<br />
®<br />
DIGITAL MUSIC AMPLIFIERS<br />
INSTALLATION AND WIRING<br />
USING SPEAKERS FOR ZONE 1 OUTPUT<br />
4 Speaker System Max. Power Output= 1/2W Each<br />
1/2W<br />
8<br />
OHM<br />
1/2W<br />
8<br />
OHM<br />
AWG 18<br />
TWISTED PAIR<br />
ZONE 1<br />
8<br />
OHM<br />
8<br />
OHM<br />
Up to Four 8 ohm Speakers may<br />
be Connected<br />
1/2W<br />
1/2W<br />
4<br />
8<br />
MOH - ZONE 1<br />
INPUT SOURCE<br />
DEFAULT JUMPER<br />
SETTING<br />
S107<br />
8 OHM<br />
2 Watt Max.<br />
24 V DC<br />
250 MA<br />
- +<br />
DMA2015<br />
15W RMS<br />
AUX1<br />
AUX2<br />
VOX<br />
SENS<br />
MUTE<br />
DELAY<br />
3 - 60 SEC<br />
SP<br />
DMA2015 Zone 1<br />
ZONE 1 OUTPUT LEVEL CONTROL<br />
Fig. 26 - Rear Panel Zone 1 Speaker Connection Diagram<br />
ZONE 1 OPERATION<br />
ZONE 1 OPERATION<br />
The Amplifier is equipped with a 2 Watt, 8 ohm Outputs designated<br />
ZONE 1 (Reference 4). The Output may be utilized<br />
to power up to 4 speakers in various combinations as<br />
described in the diagrams on the next page. This feature will<br />
provide a SECOND ZONE (in addition to the main output)<br />
with up to 2 Watt of output power and will amplify only the<br />
Source from either AUX 1 or AUX 2 (see input source selection)<br />
and will not be affected by the Paging (from MIC or<br />
TEL), VOX or MUTING.<br />
It can be used in any area (up to 2 Watt) where only a<br />
Program Source is desired uninterrupted by Paging.<br />
ZONE 1 SETTINGS<br />
INPUT SOURCE SELECTOR<br />
Independent JUMPER SETS for ZONE 1 (S107) is available<br />
to select the Input Source for the 2 Watt Amplifier.<br />
Select the Input Source desired by following the instructions<br />
in the MOH Amplifier Source Selection section.<br />
LEVEL CONTROL<br />
After the wiring is completed adjust the ZONE 1 (Reference<br />
8) Level Control on the rear panel to the desired output<br />
level.<br />
CABLE<br />
Use an AWG 18 jacketed, twisted pair cable.<br />
PAGE 26<br />
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE<br />
DMA2015/2030/2060/2120