Conveying with ease Fitting and operational manual Declaration of ...

More documents

Recommendations

Info

Fig. 7.1.5 Fig. 7.1.7 Fig. 7.2.1 ➍ ➋ ➊ Fig. 7.1.6 6 Remove the last three rollers from the roller belt (fi g. 7.1.6). 7 At the overlap, lift the roller belt fl aps (4) with a narrow screwdriver into the rollers on the inside (fi g. 7.1.7). 8 Close the belt in the curve according to the conveyor manufacturer’s instructions. 9 Check by hand that the roller chain moves easily. 10 Commission according to section 5. 7.2 Exchanging the roller belt in curve supports without insertion opening 1 Switch off the conveyor and secure from being switched on again. Caution Before carrying out any assembly, maintenance and repair work, the main switch on the conveyor must be switched off and prevented from being switched on again. 2 Open the belt in the curve according to the conveyor manufacturer’s instructions. 3 Where the curve protrudes, unscrew the screws (1) on the top guidance plate segment (2) and remove the segment (fi g. 7.2.1). 4 Exchange the roller chain as for steps 3 and 7 in section 7.1. 5 Affi x the guidance plate (2). 6 Check by hand that the roller chain moves easily. 7 Close the belt in the curve according to the conveyor manufacturer’s instructions. 8 Commission according to section 5. bmaKA_V1_E_2009.09_1000 10
8 Declaration of incorporation for incomplete machinery Assembly declaration in line with EC machine directive 2006/42/EC, appendix II b Incomplete machine: deniroll ® Kurvenabstützung; roller element for horizontal support of curved modular belts. Designation: deniroll ® curve support Manufacturer: Denipro AG Tannenwiesenstrasse 5 CH-8570 Weinfelden Person authorised to compile the assembly and operating instructions: Marco de Angelis Denipro AG Tannenwiesenstrasse 5 CH-8570 Weinfelden The manufacturer declares that the above-mentioned incomplete machine complies with the basic health and safety requirements of the EC machine directive 2006/42/EC, appendix 1. The technical documentation of this incomplete machine was drawn up in accordance with the EC machine directive 2006/42/EC, appendix VII part B. The manufacturer undertakes to forward these technical documents to government bodies if good reasons are given. Commissioning of the incomplete machine is prohibited until the incomplete machine is inserted into a machine and such machine complies with the regulations set out in the EC machine directive and an EC declaration of compliance in accordance with appendix II A has been obtained. Denipro AG CH-8570 Weinfelden, 30.8.2009 Marco de Angelis (Head of development) 11 bmaKA_V1_E_2009.09_1000
Page 1 and 2: Conveying with ease deniroll ® cur
Page 3 and 4: 2 Safety 2.1 Proper usage The denir
Page 5 and 6: 3.3 Types/included with product The
Page 7 and 8: Fig. 4.3.1 Fig. 4.3.2 Fig. 4.3.3 Fi
Page 9: 7 Repair The appearance of the roll

Conveying with ease Fitting and operational manual Declaration of ...

Create successful ePaper yourself

Delete template?

Save as template?