P-Bus Gateway Firmware PBGW2.128 Version 1.61

More documents

Recommendations

Info

P-Bus Virtual Modules (2) In this picture an example is shown in which a communication-link is created with a PRU / PRV through the P-Bus gateway. The PRU / PRV communicates with the I/O-modules via P-Bus. The P-Bus of the gateway is configured as SLAVE and is also visible by the PRU / PRV. In the virtual module-list fictive I/O-modules can be configured which are provided with information by the universal DDC controller. Click ‘add’ to create a new virtual module: 12/17 Persy Control Services B.V. Netherlands PBGW2.128 – P-bus Gateway PCS0113en 02.2009
P-Bus Virtual Modules (3) In the left column the fictive module address can be configured. By clicking on the module-type in the right column the type can be configured. A listbox is being shown in which you can choose from all available PTM-.. moduletypes. Choose the desired type. The delete a module move the indicator in the most left column to the module you wish to delete by clicking in the empty square. Click ‘delete’. To delete all modules click ‘clear all’. If all desired virtual modules are entered into the table you need to store the table into the gateway’s non-volatile memory by clicking ‘apply’. If you wish to discard the changes you made in the table click ‘discard’. Persy Control Services B.V. Netherlands PBGW2.128 – P-bus Gateway 13/17 PCS0113en 02.2009
Page 1 and 2: P-Bus Gateway Firmware PBGW2.128 Ve
Page 3 and 4: Select ‘Use the following IP addr
Page 5 and 6: Device Setup TCP / IP Settings NOT
Page 7 and 8: P-Bus Settings (1) In this page yo
Page 9 and 10: P-Bus Modulelist (1) . This page d
Page 11: P-Bus Virtual Modules (1) Open com
Page 15 and 16: ModBus Registers Each PTM I/O-modul
Page 17: Firmware upgrade The firmware in th

P-Bus Gateway Firmware PBGW2.128 Version 1.61

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?