Catalogue ELS/SV - Lumentron Electronic Kft.

ELS - SV
Specification text and technical data
850
785
INOTEC ELS-SV emergency lighting system
with Joker-technology, for the supply and
monitoring of up to 60 safety- or exit
luminaries. Each outgoing circuit is for 15
luminaries in maintained, non-maintained or
switched maintained mode either mixed or in
one mode on the line. The ELS/SV system
incorporates:
- battery for 1h or 3h duration
- charger
- 4 converters, each suitable for 15 monitored
luminaries, max. converter load 120W.
- control module with two-line liquid crystal
display for status information in national
language
- light-switch-monitor and Joker- technology
- delay on mains return option (0 - 15 min)
Mains supply: 230/240 V AC
Output voltage mains: 230/240 V AC
Output voltage battery: 220 V DC
Rated duration: 1h or 3h
Protection class I, protection category IP 40
Max. permissible ambient temp. : -5°C to +40°C
Weight:
With 17 Ah batteries 32kg
With 34 Ah batteries 46kg
325 100
400
Mechanical design:
Powder coated (RAL 7032) sheet steel housing
with separate battery compartment.
OCTA-aluminium profile door with clear
polycarbonate inlay, lhs door hinges. Separate
internal covers for battery-, terminal- and
electronic compartment. Block diagram with
technical data on electronic compartment
cover. Housing with internal earth contacts.
Cable inlets top. Battery and terminal /
electronics compartment with ventilation
slots. The ELS-SV is suitable for wall mounting
(fixing details 325 x 765 mm; hole ø 6 mm).
Total ( H x W x D) 870 x 420 x 105 mm
870
420
105
Electrical design:
Supply- (max. 1 x 4 mm² ) and outgoing
circuits (max. 2 x 2,5 mm² ) are prewired to
terminals located on the central terminal rail.
The cable inlets on the top of the enclosure
are predrilled and closed with rubber blind
plugs M20. Battery- and mains fuses for
charger and each converter are included.
Creepage- and clearance distances are in line
to IEC standards.
Three volt-free contacts (3xno) for the remote
failure/status indication are available.
Maintained and non-maintained circuits can
be freely programmed via the control module.
Mixed operation of maintained-,
non-maintained- and switched maintained
luminaries on any final end circuit
(Joker-technology) is always possible.
24 V monitoring loop
Each ELS-SV has the terminals to connect
external phase monitors (DPÜ). They are used
to monitor sub-distributions for general
lighting or individual lighting circuits. The max.
cable run allowed is 2000m with 1,5 mm².
Charger 3A:
Temperature controlled constant voltage
charger, current limited, with boost charge
function. Battery voltage monitoring and time
-controlled trickle charge function. Chargers
failures are visual via a red "charge failure" LED
on the left side of the display area.
Recharge time: