Catalogue ELS/SV - Lumentron Electronic Kft.

ELS - SV
JOKER - Technology
Joker-technology function
Each ELS-SV change-over device is
able to foster three differing luminaire
switching modes on the same output
at the same time (see page 4).
In addition to the system, luminaries
with Joker high frequency electronic
ballast (common standard on INOTEC
luminaries) or Joker switch modules,
J/SV-module/S, for third party
electronic ballast, must be used.
These components allow the easy
setting of monitoring address and
luminaire mode.
The patented JOKER-technology of
INOTEC reduces the design- and
installation time and cuts down on
material cost.
The sample to the right shows the
reduction on installation material and
circuit layout.
Conventional emergency lighting
sys-tems and installations with the
three possible standard switching
modes maintained (DL)-,
non-maintained (BL)- and switched
maintained (gDL) mode, require 6 final
end circuits to feed 9 luminaries in a
part of the building shown.
The Joker-Technology reduces the
number of circuits required. Our sample
needs only 2 final end circuits to feed
the same number of luminaries due to
the fact that the operation of all switching
modes on one circuit is possible.
The maintained and switched
main-tained luminaries are active
during mains presence. During mains
failure however, all luminaries will be
switched on and supplied by the
battery (see page 6).
Advantages of the Joker-technology
Simple design and engineering
Reduced installation material
content (cable reductions, see page
6 - non-maintained mode, sense
input)
Conventional installation
requires
6 final end circuits
circuit 5
circuit 6
circuit 1
Joker-technology with
2 final end circuits
circuit 3 circuit 4
Maintained mode Non-maintained
mode
Cut down on installation time
Higher load level for final end
circuits
Switching mode settable on each
luminaire
circuit 2
circuit 1 circuit 2
Switched maintained
mode
5