Catalogue Measurement Technology ProGrit

Measurement Set Up and Measurement System APC-4i for Measuring
under Compaction Force
The shown measurement setup allows the measurement of the radial
rigidity of the system of press, die set and reference clamping system
under the action of a compaction force. The measurement is done in
the radial directions X and Y with the help of four probes and a round
measurement pin (e.g. P-002 684).
Under the influence of the compaction force the round elastomer
spring element is deformed and the radial movement of the
measurement pin is measured.
The measured deflections provide information about the rigidity of
the system press, die set and reference clamping system in the
compaction process under compressive force.
Measurement Die AD 135 Power P for RCS, PM Precise and PM Multi
Product number P-005 985
Material
Steel hardened stainless,
aluminum, plastic
Mechanical interface RCS 135
PM 128 Precise / PM 128 Multi
Max. allowed pressure 13 500 N
elastomer spring
Application
Measurement of radial rigidity
of system press, die set and
reference clamping system
Probes 4 x P43*
D x H
135 x 85 mm
Weight
4,5 kg
* Probes not in scope of delivery.
Measurement Pin AP 60 Power P for RCS, PM Precise and PM Multi
Product number P-002 684
Material
Steel hardened stainless
Mechanical interface RCS 60
PM 56 / 60 Precise
PM 56 Multi
Clamping
Pneumatic
Application
Measurement of radial rigidity
of system press, die set and
reference clamping system
d x L*
30 x 120 mm
Weight
1 kg
* Further lengths on request.
18 Alignment Measurement Powder Compaction 4.0