Catalogue Measurement Technology ProGrit

For difficult to access presses and die sets a small LCD display is optionally
available and shows the most important measurement data.
User friendly software and graphical alignment navigation
leads to highest alignment accuracy
- Intuitive menu driven operation
- Graphical alignment navigation
- No reading errors or incorrect operation
- Setting of accuracy limits
Intelligent measurement concept
- Automatic compensation of form and position tolerances of
the alignment tools
- Automatic compensation of temperature response
Automatic digital logging
- Automatic digital recording of the initial position and the alignment
results
- Date stamp
- Calculation of change in position of reference clamping systems - Life
Cycle Management
- Protocol storage by USB interface in a central data pool
- Traceability of alignment results
Benefit
- 20 times higher measurement and alignment accuracy compared with
conventional measurement and alignment systems
- Positioning accuracy in the resolution of 1/10 micron and 1 arc second
possible
- Increasing of the compaction quality and symmetrical distribution of the
compaction clearance – burr free or burr less compaction
- Reduction of the alignment and inspection times by 80%
- Reduction of cost of compaction tools by 75% because of less wear and
fractures of the compaction tools
- Increased life time of compaction tools.
Following presses, die sets and reference clamping systems are supported:
- Presses and die sets: Dorst, Erowa, Fette, Kobayashi, Komage, Lauffer,
Precision Compacting, Proment, Osterwalder, Sacmi, System 3R°
- Reference clamping systems: Erowa, ProGrit, System 3R°
Alignment Measurement Powder Compaction 4.0 21