LAN Configuration
LAN Configuration
LAN Configuration
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
the station supports routing (CPUs und CPs). More<br />
information you will get in the "STEP 7 Online Help".<br />
Parameter of the partner<br />
Address Enter the IP Address of the MPI – <strong>LAN</strong> cable which is<br />
plugged onto the PLC.<br />
Slot Enter the slot number of the destination CPU.<br />
Construction<br />
Enter the construction components.<br />
components<br />
Cyclic operation If this check box is active the PLC optimizes the<br />
operation between ProTool/Pro Runtime and the PLC.<br />
This is used to get a better performance. For Parallel<br />
operations of more than one computers the cyclic<br />
operation check box should be deactivated.<br />
Confirm the configuration with “OK“.<br />
4. Complete the project<br />
Click on “Next“ and then on “Complete“ to end the project start configuration.<br />
5. Alternative configuration<br />
If you select the group “Controls“ in the left part of the window you can see the<br />
available PLCs in the right part. Right click with the mouse button on the PLC and<br />
select “Properties” in order to get back to the configuration dialog we used in the<br />
project configuration at the beginning.<br />
At least to get there you have to click<br />
on “Parameter“.<br />
6. Transfer properties<br />
In the file menu click on „Transfer“ �<br />
„Properties…“ and the following dialog<br />
appears.<br />
Choose “Ethernet“ so that the<br />
connection can be established in the<br />
CP mode.<br />
If “Ethernet“ is activated you can enter<br />
the “IP address“ of the destination<br />
device (MPI – <strong>LAN</strong>). Confirm with<br />
“OK“ to complete the configuration.<br />
7. <strong>Configuration</strong> is complete<br />
Now you can transfer the project.<br />
Page 42 Cable and adapter manual © by PI 2008
Change language