LAN Configuration

d. Config
o Mode
o Password
o Reset
o Set Def.
o Language
o S7toS5S7
o Protocol
o PG/PC
o MPI – BUS
o IP Adr
o SNetMask
o Gateway
o DHCP
o Data
• Mode
Choose this menu to change the cables way of working.
Available selections: “MPI – LAN“ – Normal MPI – LAN mode
“PPIMulti“ – S7 200 Multimaster mode
“PPILAN19“ – S7 200 PPI 19.2KBaud
“SOND_LAN“ - Special LAN baud rate
“SOND_SER“ – Special Serial baud rate
“PPILAN96“ – S7 200 PPI 9.6KBaud
• Password
Choose this menu to change the password of the cable – configuration.
(Default: “0“).
• Reset
Press � to perform a system reset.
• Set Def.
Press the Enter – Key � to load the default configuration.
• Language
In this sub menu you can choose your desired language.
Available selections “German“ und “English“.
• S7toS5S7
This menu is to configure connections to other PLCs. To get more information read
chapter 1.6.2.
Page 48 Cable and adapter manual © by PI 2008