Installation Manual Truck Edition V-520 Series Single ... - Thermo King

More documents

Recommendations

Info

HOST EVAPORATOR <strong>Installation</strong> - Drain Hoses SPECTRUM Multi-Temperature Systems with (2) ES-300 Evaporators 1. Cut the drain hose into two sections of suitable length and attach onto the drain tubes. 2. Allow approximately 7.00 in. (180 mm) of defrost wire to extend from each defrost tube into the pan. 3. Insert the defrost heater wires through each drain hose and along its entire length. • Do not use band wraps (wire ties) to hold the defrost heater wires. • Do not cover or wrap the defrost heater wires. • Do not cut the defrost heater wires. • Do not install more than 4 defrost heater wires into the drain tube. 4. Install the cover onto the evaporator. 5. Secure the connections with tie bands. 6. Route both hoses directly out through the compartment wall and join to a third single drain hose using the Y connector. 7. Route the single drain down the outside of the cargo box and secure with clamps. 8. Seal the drain hose holes in the cargo box with caulking. REMOTE EVAPORATOR 1. Install the cover onto the evaporator. 2. Cut the drain hose into two sections of suitable length and attach each drain hose onto the evaporator drain tubes. 3. Allow the drain hoses a sufficient slope to ensure that the water drains away. 4. Secure the connections with tie bands. 5. Route both hoses directly out through the compartment wall and join to a third single drain hose using the Y connector. 6. Route the single drain down the outside of the cargo box and secure with clamps. 7. Seal the drain hose holes in the cargo box with caulking. 50
<strong>Installation</strong> - Drain Hoses SPECTRUM Multi-Temperature Systems with (2) ES-300 Evaporators Defrost Heater Wires Defrost Heater Wires Host Evaporator (with Defrost Heaters) Remote Evaporator (without Defrost Heaters) 51
Page 1 and 2: Installation Manual Truck Edition V
Page 3 and 4: This manual was written to assist w
Page 5 and 6: Recover Refrigerant At Thermo King,
Page 7 and 8: WARNING: Never drill holes in the u
Page 9 and 10: Tips for a Successful Installation
Page 11 and 12: Required Tools 11
Page 13 and 14: Approximate Weight: ES-300 = 18 kg
Page 15 and 16: In-Cab Controller Dimensions A. 140
Page 17 and 18: Installation - Vehicle Powered Comp
Page 19 and 20: Installation - V-520 Condenser 19
Page 21 and 22: Installation - (1) ES-500 Evaporato
Page 23 and 24: Installation - (2) ES-300 Evaporato
Page 25 and 26: Cut the Hose 1. Cut the hose to pro
Page 27 and 28: Snap on the Cage 5. Snap the cage i
Page 29 and 30: CAUTION: TK 2000 Speedy Clip System
Page 31 and 32: Installation - Refrigeration Hoses
Page 33 and 34: LIS-01/CLU-2 Installation - Jet Coo
Page 43 and 44: System Leak Check and Evacuation 43
Page 45 and 46: Electrical Connections - Evaporator
Page 47 and 48: Electrical Connections - Evaporator
Page 49: Installation - Drain Hoses Single T
Page 53 and 54: Installation - In-Cab Controller 53
Page 55 and 56: Installation - Electric Standby Pow
Page 57 and 58: Electrical Connections - Engine Com
Page 59 and 60: System Charging 59
Page 61 and 62: All mounting holes and access holes
Page 63: Wiring Diagram and Wiring Schematic

Installation Manual Truck Edition V-520 Series Single ... - Thermo King

Create successful ePaper yourself

Delete template?

Save as template?