CRT 48 Operation - Wacker Neuson
CRT 48 Operation - Wacker Neuson
CRT 48 Operation - Wacker Neuson
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance <strong>CRT</strong> <strong>48</strong><br />
3.14 Engine Oil and Filter–Vanguard Engines<br />
See Graphic: wc_gr000217, wc_gr003803<br />
Change oil and oil filter (d) every 100 hours. On new machines,<br />
change oil after first 50 hours of operation. Drain oil while engine is still<br />
warm.<br />
Note: In the interests of environmental protection, place a plastic sheet<br />
and a container under the machine to collect any liquid which drains<br />
off. Dispose of this liquid in accordance with environmental protection<br />
legislation.<br />
Drain oil while engine is still warm.<br />
3.14.1 Remove oil fill cap (a) and drain plug (b) to drain oil.<br />
3.14.2 Install drain plug and torque to 34.6 Nm (25.5 ft.lbs.).<br />
3.14.3 Fill engine crankcase with recommended oil until the level is between<br />
“L” and “F” on the dipstick (c). See Technical Data for oil quantity and<br />
type.<br />
3.14.4 Install oil fill cap.<br />
3.14.5 To replace the oil filter (d), remove the installed oil filter after oil has<br />
been drained. Apply a thin coat of oil to the rubber gasket of the<br />
replacement oil filter. Screw the filter on until it just contacts the filter<br />
adapter, then turn it an additional ½ turn. Refill with oil as described<br />
above.<br />
wc_tx000642gb.fm 38