Junos OS Interfaces Configuration Guide for ... - Juniper Networks

Junos OS Interfaces Configuration Guide for Security Devices
18
Related
Documentation
The first octet of 1s identifies the address as a multicast address. The flags field identifies
whether the multicast address is a well-known address or a transient multicast address.
The scope field identifies the scope of the multicast address. The 112-bit group ID identifies
the multicast group.
Similar to multicast addresses, anycast addresses identify a set of interfaces. However,
packets are sent to only one of the interfaces, not to all interfaces. Anycast addresses
are allocated from the normal unicast address space and cannot be distinguished from
a unicast address in format. Therefore, each member of an anycast group must be
configured to recognize certain addresses as anycast addresses.
•
Junos OS Feature Support Reference for SRX Series and J Series Devices
• Understanding Interface Logical Properties on page 12
• Understanding IPv4 Addressing on page 13
• Configuring the inet6 IPv6 Protocol Family on page 18
• Enabling Flow-Based Processing for IPv6 Traffic on page 19
Configuring the inet6 IPv6 Protocol Family
In configuration commands, the protocol family for IPv6 is named inet6. In the
configuration hierarchy, instances of inet6 are parallel to instances of inet, the protocol
family for IPv4. In general, you configure inet6 settings and specify IPv6 addresses in
parallel to inet settings and IPv4 addresses.
NOTE: On SRX Series devices, on configuring identical IPs on a single
interface, you will not see a warning message; instead, you will see a syslog
message.
The following example shows the CLI commands you use to configure an IPv6 address
for an interface:
[edit]
user@host# show interfaces
ge-0/0/0 {
unit 0 {
family inet {
address 10.100.37.178/24;
}
}
}
[edit]
user@host# set interfaces ge-0/0/0 unit 0 family ?
Possible completions:
+ apply-groups Groups from which to inherit configuration data
+ apply-groups-except Don't inherit configuration data from these groups
> ccc Circuit cross-connect parameters
> ethernet-switching Ethernet switching parameters
> inet IPv4 parameters
> inet6 IPv6 protocol parameters
> iso OSI ISO protocol parameters
Copyright © 2011, Juniper Networks, Inc.