Waves User Guide - V2

More documents

Recommendations

Info

This check-in list can be completed by selecting one by one or if the check-in button at the top is clicked, all competitors / teams will be checked in. By clicking this again, it will unselect the whole list. Once checked-in, the total amount of competitors / teams will be shown in the bottom left corner (4/39 Figure 10 above) then click the Completed green button at the bottom right of the page. Marshalling Via Scanning When marshalling competitors / teams, the first step is to check them off to say they are on the starter’s line. To do this, click into the Scan RFID box located top right and then start scanning the RFID attached to athletes vests or wristbands. A box notifying you of the successful scan will appear and the athletes name will be ticked off automatically. Once you have finished marshalling click the Completed box located in the bottom right corner of the page. (Figure 10) Scratching an Event If an Event is no longer being held you can scratch the entire event by clicking the three dots on the right beside the event and select Scratch. If you make a mistake and need to restore the event back into Upcoming events tab, click on the Scratched events tab and click the three dots to the right of the event and click Restore. Figure 11 – Scratching/Unscratching User Guide – V2 10
Scratching an Athlete or Team If an athlete or team is not racing you can scratch them from the event by clicking the three dots on the right beside the athlete or team and select Scratch/Unscratch. If you make a mistake and need to unscratch click the three dots again and select Scratch/Unscratch again. When a athlete or team is scratched then the athlete or team will have lines through the names as shown below. Scratch team example. Click on the three dots and select Scratch/Unscratch Figure 12 – Scratching/Unscratching User Guide – V2 11
Page 1 and 2: User Guide - V2 1
Page 3 and 4: Introduction to Waves Waves has bee
Page 5 and 6: Competition Settings When you first
Page 7 and 8: Below are four examples of points t
Page 9: Click on the green Marshal button.
Page 13 and 14: Check Marshalling Once the initial
Page 15 and 16: Once you have selected your Rounds
Page 17 and 18: Progressing Following Rounds Now th
Page 19 and 20: Progressing from Heats or Rounds to
Page 21 and 22: Now you are ready to Marshal and Ch
Page 23 and 24: Click the drop drop down menu and s
Page 25 and 26: Click the drop drop down menu and s
Page 27 and 28: Editing Wave Numbers After wave num
Page 29 and 30: RFID Tag Search To search for an RF
Page 31 and 32: Lane Draw Report - If you wish to p
Page 33 and 34: Media Report - Allows you to create
Page 35: For any further information or ques

Waves User Guide - V2

Create successful ePaper yourself

Delete template?

Save as template?