id-fpc-global-guide_3_manual

4.9 Remote control and data logging
4.9.1 Direct connection to the PC
CONTROLLER can be connected directly with PC via optional IL-NT RS232 interface.
Use the standard serial cable to connect PC with CONTROLLER.
Note: Make sure the grounding system on controller and PC – COM port (negative of the PC DC supply) are
identical – before the first direct connection. There must not be any voltage between these two points otherwise
the internal reversible fuse in controller burns out. The simple solution is to assure, that the PC supply 240/20V
is ground free (GND terminal is not connected).
4.9.2 PC software - LiteEdit
On the PC (for direct or modem connection) has to be installed the ComAp’s software package LiteEdit. (based
on Windows 95 or newer platform)
LiteEdit enables:
read the quantities
adjust all set points
control the engine
configure the controller
select software configuration
modify alarm inputs and outputs
modify password, commands protections
direct, modem or Internet communication
language translator
Language translator
Default archive contains English and Chinese languages. To change default Chinese (Unicode) to any Latin
language use Remove and Add buttons in LiteEdit – Translator-Language window.
ID-Lite FPC 1.6.0 Global Guide 48