Addendum to PAL User Manual Installation and ... - PAL System

note
1.1. Specifications
Part number: PAL ITEX-2 Option
Description: PAL ITEX-2 Option for COMBI PAL
Headspace Syringe: PNo.: SyrC ITEX-2-1.3, Volume 1.3 mL*
Addendum to PAL System User Manual
PAL ITEX-2 Option
Syringe Heater: PNo.: MSH 05-01; Syringe ID#: 25
Temperature range: 30-150 o
C
Trap Heater: PNo.: ITEX-2 Trap Heater
Temperature range: 30 – 350 o C
Heating-up rate: 30 to 250 o C: 25 – 30 seconds
Cooling-off time: 250 to 70 o C: approx. 3 minutes
Cooling-off time: 250 to 40 o C: approx. 5 minutes
Cooling-off time: 250 to 30 o C: approx. 7 minutes
(requires AUX interface connection, standard is AUX2)
*Nominal volume: 1.3 mL.
Syringe Maximum Scale Length: 27 mm = 1.125 mL actual syringe volume.
ITEX-2 Trap
• Material: Stainless steel, deactivated by SilTek®
• Needle: Injection needle gauge 23 (O.D. 0.63 mm)
Point style 5 (side-hole)
Injection needle length: 41 mm
• Trap: Upper part of needle 3.20 mm O.D.
Standard trap material: Tenax TA
80/100 mesh, fill volume 44 mg
Upper temperature limit: 350 °C
(Other trap material is available; see section
‘Appendix, Spare Parts’.)
• Gas Flow: 4 mL/min +/- 1 mL/min
Restrictor for pressure regulator outlet is provided.
Net Weight: Approx. 210 g (total weight including trap heating
cable)
Dimension: Height: 160 mm
Width: 78 mm (total width including side adapter of
cartridge)
PAL Firmware: PAL System: Version 2.5.2 or higher
PAL-xt System: Version 4.1.X or higher
Software Control: Using Cycle Composer Software Version 1.6.0
(current version 1.6.0; any lower version is suitable as
long as serial communication is selected),
or PAL ICC (Cycle Editor).
9