CR Manual CP L&M en - Creation Willi Geller

More documents

Recommendations

Info

I N J E C T I N G KLEMA Press 100g Mould 200g Mould 300g Mould Stand-by Temperature 800 °C 800 °C 800 °C Sealing Time 00:00 min. 00:00 min. 00:00 min. Heat Rate 60 °C/min. 60 °C/min. 60 °C/min. Vacuum Start 800 °C 800 °C 800 °C Vacuum Hold 30:00 min. 30:00 min. 37:00 min. Vacuum Limit 730 mm 730 mm 730 mm Firing Temperature 930 °C 940 °C 975 °C Holding Time 20:00 min. 20:00 min. 25:00 min. Injection Temperature 930 °C 940 °C 975 °C Injection Time 10:00 min. 10:00 min. 12:00 min. These firing parameters represent standard values and have to be adjusted to respective situation. 10 | LOW & M E TA L
DEVESTING 11 | LOW & M E TA L Mark the length of the plunger on the mould and separate along the length of the mark. Then carefully break apart the sections of the mould. The pressings should be roughly blasted with glass beads (50 μm) at 4 bars with a pen blaster, then carefully with glass beads (50 μm) at 2 bars. Do not use aluminium oxide for blasting!
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 I N T R O D U C T I O N Creation
Page 5 and 6: TOOTH PREPARATION 1,5 2,0 1,5 1,5 2
Page 7 and 8: WA X I N G - U P - S TA I N I N G T
Page 9: INVESTING 9 | LOW & M E TA L Push t
Page 13 and 14: STAINING TECHNIQUE 13 | L O W The o
Page 15 and 16: G L A Z E F I R I N G 15 | L O W Sm
Page 17 and 18: COLOUR CHART TRANSPARENT PELLETS 2g
Page 19 and 20: 19 | M E TA L I N T R O D U C T I O
Page 21 and 22: C U T B A C K T E C H N I Q U E - M
Page 23 and 24: C U T B A C K T E C H N I Q U E 23
Page 25 and 26: C U T B A C K T E C H N I Q U E - P
Page 27 and 28: C U T B A C K E A S Y T E C H N I Q
Page 29 and 30: STAINING POSTERIORS 1 4 7 29 | M E
Page 31 and 32: C U T B A C K - C O M B I N AT I O
Page 33 and 34: S TA I N I N G P O S T E R I O R -
Page 36: 36 Distributor Creation Willi Gelle

CR Manual CP L&M en - Creation Willi Geller

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?