CR Manual CP L&M en - Creation Willi Geller

More documents

Recommendations

Info

C U T B A C K T E C H N I Q U E - P R E S S PA R T 24 | M E TA L INVESTING See low technique (p. 8 – 9). P R E S S I N G See press parameter (p. 10, 30). DEVESTING See low technique (p. 11).
C U T B A C K T E C H N I Q U E - P R E S S PA R T 25 | M E TA L FINISHING Cut off the sprues carefully using a suitable cut-off-disc. Work with low pressure and low r.p.m. (revolutions per minute). After separating, the work is carefully fitted onto the die (caution in the area metal press ceramic. Int<strong>en</strong>se heat can cause breaks!). The fully anatomically modelled restoration should be reduced or prepare the already reduced restoration for v<strong>en</strong>eering.
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 I N T R O D U C T I O N Creation
Page 5 and 6: TOOTH PREPARATION 1,5 2,0 1,5 1,5 2
Page 7 and 8: WA X I N G - U P - S TA I N I N G T
Page 9 and 10: INVESTING 9 | LOW & M E TA L Push t
Page 11 and 12: DEVESTING 11 | LOW & M E TA L Mark
Page 13 and 14: STAINING TECHNIQUE 13 | L O W The o
Page 15 and 16: G L A Z E F I R I N G 15 | L O W Sm
Page 17 and 18: COLOUR CHART TRANSPARENT PELLETS 2g
Page 19 and 20: 19 | M E TA L I N T R O D U C T I O
Page 21 and 22: C U T B A C K T E C H N I Q U E - M
Page 23: C U T B A C K T E C H N I Q U E 23
Page 27 and 28: C U T B A C K E A S Y T E C H N I Q
Page 29 and 30: STAINING POSTERIORS 1 4 7 29 | M E
Page 31 and 32: C U T B A C K - C O M B I N AT I O
Page 33 and 34: S TA I N I N G P O S T E R I O R -
Page 36: 36 Distributor Creation Willi Gelle

CR Manual CP L&M en - Creation Willi Geller

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?