CR Manual CP L&M en - Creation Willi Geller

More documents

Recommendations

Info

C U T B A C K T E C H N I Q U E - M E TA L PA R T 1 20 | M E TA L ALLOY Overpress technique: Alloys with a coefficient thermal expansion between 13,8 – 14,2 (25 ° – 500 °C) can be used. This information is not obligatory. Please check the alloys suitabilities for the press over technique before you start using it. WAXING-UP It is recommended to produce a diagnostic wax-up to position the framework pattern correctly. You wax-up a little reduced as with the MC technique with full shoulder. The pattern should correspond to the reduced tooth mould to guarantee constant layer thickness. The later metal part should be kept as small as possible to avoid tension with the press ceramics.
C U T B A C K T E C H N I Q U E - M E TA L PA R T 2 3 4 21 | M E TA L SPRUEING - CASTING - FINISHING - OXIDIZING Refer to the alloy manufacturer`s instructions. FIRST OPAQUE FIRING Use the Creation CC Paste or Powder Opaque. Apply the opaque evenly that the metal is masked 75%. SECOND OPAQUE FIRING The opaque should have a shiny surface after firing. The second coating of opaque should mask the metal completely. The fired surface should shine lightly.
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 I N T R O D U C T I O N Creation
Page 5 and 6: TOOTH PREPARATION 1,5 2,0 1,5 1,5 2
Page 7 and 8: WA X I N G - U P - S TA I N I N G T
Page 9 and 10: INVESTING 9 | LOW & M E TA L Push t
Page 11 and 12: DEVESTING 11 | LOW & M E TA L Mark
Page 13 and 14: STAINING TECHNIQUE 13 | L O W The o
Page 15 and 16: G L A Z E F I R I N G 15 | L O W Sm
Page 17 and 18: COLOUR CHART TRANSPARENT PELLETS 2g
Page 19: 19 | M E TA L I N T R O D U C T I O
Page 23 and 24: C U T B A C K T E C H N I Q U E 23
Page 25 and 26: C U T B A C K T E C H N I Q U E - P
Page 27 and 28: C U T B A C K E A S Y T E C H N I Q
Page 29 and 30: STAINING POSTERIORS 1 4 7 29 | M E
Page 31 and 32: C U T B A C K - C O M B I N AT I O
Page 33 and 34: S TA I N I N G P O S T E R I O R -
Page 36: 36 Distributor Creation Willi Gelle

CR Manual CP L&M en - Creation Willi Geller

Create successful ePaper yourself

Delete template?

Save as template?