CR Manual CP L&M en - Creation Willi Geller

More documents

Recommendations

Info

B U I L D - U P 14 | L O W Layering with Creation LF. Before layering, a characterisation firing with Creation CC.LF. Make Up Instant stains can be fixed. Missing areas of dentine can be added using dentine porcelain. The incisal parts are added to the anatomical form, then fired as specified in the firing chart. Firing is performed on firing cotton or thin metal firing pins (use platinfoil), but molars should only be fired on firing pad. A correction firing can be carried out, if necessary. A minimum thickness of 0,8 mm must be observed or 2/3 of the anatomical form must consist of pressable ceramic!
G L A Z E F I R I N G 15 | L O W Small individual nuances can now be added with Creation CC.LF. Make Up Instant stains. Finally, carry out glazing or mechanical polishing.
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 I N T R O D U C T I O N Creation
Page 5 and 6: TOOTH PREPARATION 1,5 2,0 1,5 1,5 2
Page 7 and 8: WA X I N G - U P - S TA I N I N G T
Page 9 and 10: INVESTING 9 | LOW & M E TA L Push t
Page 11 and 12: DEVESTING 11 | LOW & M E TA L Mark
Page 13: STAINING TECHNIQUE 13 | L O W The o
Page 17 and 18: COLOUR CHART TRANSPARENT PELLETS 2g
Page 19 and 20: 19 | M E TA L I N T R O D U C T I O
Page 21 and 22: C U T B A C K T E C H N I Q U E - M
Page 23 and 24: C U T B A C K T E C H N I Q U E 23
Page 25 and 26: C U T B A C K T E C H N I Q U E - P
Page 27 and 28: C U T B A C K E A S Y T E C H N I Q
Page 29 and 30: STAINING POSTERIORS 1 4 7 29 | M E
Page 31 and 32: C U T B A C K - C O M B I N AT I O
Page 33 and 34: S TA I N I N G P O S T E R I O R -
Page 36: 36 Distributor Creation Willi Gelle

CR Manual CP L&M en - Creation Willi Geller

Create successful ePaper yourself

Delete template?

Save as template?