CR Manual CP L&M en - Creation Willi Geller

More documents

Recommendations

Info

F I N I S H I N G 12 | L O W Carefully remove the sprue pins with a suitable cut-off disc. Now fit the pressed parts onto the die and then depending on the technique used - carry out the finishing. BUILD-UP TECHNIQUE The fully anatomically modelled restoration should be reduced with finishing abrasives that are suitable for working porcelain or if the restoration was reduced before wax-up, prepare it for veneering. Before layering, the surface should be blasted with aluminium oxide (50 μm) and very slight pressure (1bar). Layering can be started after through cleaning (steam blaster/ultrasonic cleaner). Minimum framework thickness 0,8 mm or rather 2/3 of the anatomical form must consist of pressable ceramic!
STAINING TECHNIQUE 13 | L O W The objects are ready-finished (contact points, surface texture etc.). When using silicone rubber polisher, blasting with aluminium oxide (50 μm) and slight pressure (1bar) are required. Any corrections can still be made with the Creation LF layering porcelain before staining. Individual characterisation is then done with the Creation CC.LF. Make Up Instant stains. One or more stain firings may be carried out, depending on the situation. Then glaze the ready-stained restoration once or twice.
Page 1 and 2: CREATION WILLI GELLER INTERNATIONAL
Page 3 and 4: 3 I N T R O D U C T I O N Creation
Page 5 and 6: TOOTH PREPARATION 1,5 2,0 1,5 1,5 2
Page 7 and 8: WA X I N G - U P - S TA I N I N G T
Page 9 and 10: INVESTING 9 | LOW & M E TA L Push t
Page 11: DEVESTING 11 | LOW & M E TA L Mark
Page 15 and 16: G L A Z E F I R I N G 15 | L O W Sm
Page 17 and 18: COLOUR CHART TRANSPARENT PELLETS 2g
Page 19 and 20: 19 | M E TA L I N T R O D U C T I O
Page 21 and 22: C U T B A C K T E C H N I Q U E - M
Page 23 and 24: C U T B A C K T E C H N I Q U E 23
Page 25 and 26: C U T B A C K T E C H N I Q U E - P
Page 27 and 28: C U T B A C K E A S Y T E C H N I Q
Page 29 and 30: STAINING POSTERIORS 1 4 7 29 | M E
Page 31 and 32: C U T B A C K - C O M B I N AT I O
Page 33 and 34: S TA I N I N G P O S T E R I O R -
Page 36: 36 Distributor Creation Willi Gelle

CR Manual CP L&M en - Creation Willi Geller

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?