CR Manual CP L&M en - Creation Willi Geller
CR Manual CP L&M en - Creation Willi Geller
CR Manual CP L&M en - Creation Willi Geller
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INVESTING<br />
9 | LOW & M E TA L<br />
Push the silicone ring on the crucible former. Fill to just below<br />
the edge of the silikon ring with special investm<strong>en</strong>t for injection<br />
moulded ceramics. Put on the mould base former turning g<strong>en</strong>tly<br />
(investm<strong>en</strong>t should exude easily through the op<strong>en</strong>ing). After the<br />
investm<strong>en</strong>t has set, turn the mould base former and mould former<br />
carefully to remove them. Smooth the underside with a plaster<br />
knife. Follow the directions for preheating in the instructions for<br />
use for the investm<strong>en</strong>t.<br />
Important: Do not preheat the pellets!<br />
Preheat the aluminium plunger!<br />
Do not preheat the one-way plunger!
Change language