Searching for connected SLS-500 PLCs - Hiquel
Searching for connected SLS-500 PLCs - Hiquel
Searching for connected SLS-500 PLCs - Hiquel
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Tech Note: TERM4 – adjustment with <strong>SLS</strong>-<strong>500</strong> <strong>PLCs</strong><br />
Products: For all <strong>SLS</strong>-<strong>500</strong> Main Controllers and all <strong>SLS</strong>-<strong>500</strong>-Configurator versions<br />
Revision: R100<br />
Requirements<br />
HIQUEL-TERM4 Terminal, a Interface-cable Term4-<br />
<strong>SLS</strong> connection cable and a <strong>SLS</strong>-<strong>500</strong> Main Controller<br />
(group C or D).<br />
Setup mode<br />
Assure that your HIQUEL-TERM4 is <strong>connected</strong> with<br />
the <strong>SLS</strong>-<strong>500</strong> Main Controller and that the voltage<br />
supply is working, but TERM4 must be switched off .<br />
Now press the three marked arrow keys<br />
simultaneously. Keep them pressed and switch on the<br />
terminal. The setup menu will be displayed after<br />
approximately 5 seconds.<br />
HIQUEL ® GmbH Bairisch Kölldorf 266, A - 8344 Bad Gleichenberg<br />
Tel: +43-3159-3001, Fax: +43-3159-30014, e-mail: hiquel@hiquel.com http: www.hiquel.com<br />
Now you are in setup mode of the HIQUEL-TERM4<br />
terminal.<br />
Adjust the parameters of your TERM4 to the<br />
following:<br />
Contrast: 50%<br />
Bus number: 0<br />
Baud rate: 19200 8N1<br />
Communication mode: PROTECTED
Change language